Service Manuals, User Guides, Schematic Diagrams or docs for : Agilent 3458A service 03458-90032 Opt001 install

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download 03458-90032 Opt001 install documenatation <<

Text preview - extract from the document

Agilent 3458A Option 001 Installation Note
Thank you for purchasing the Agilent 3458A Option 001 Extended Memory Upgrade kit (P/N 03458-87902)!

This document contains the procedure for installing the extended memory option 001 to a standard 3458A
Serial Number US2803152 and greater. For units with serial number US2803152 and below that have NOT
updated the 3458A WITH KIT P/N 03458-88047, the correct P/N is 03458-87901

For the most up-to-date information on the Agilent 3458A, go to www.agilent.com/find/3458a.

                                             CAUTION
Use clean-handling and anti-static techniques when handling and installing the IC.

Removing the Top Cover

    1. Remove both rear handle brackets with a #2 Pozidrive.

    2. Remove the rear bezel by loosening the four #15 TORX screws.

    3. With the back of the instrument facing you, remove the #10 TORX screw securing the top
       cover to the right side. NOTE: This screw provides ground continuity to the cover.

    4. Remove the top cover.

Installing the RAM

    5. Remove the PAL U102, and install the NEW PAL U102 on the 03458-66545 Outguard
       Controller Assembly (Figure 1). This converts the assembly to an Option 001 03458-66548.

    6. Install the 03458-66548 label on the PC board (Figure 2).

Reinstalling the Top Cover

    7. Reverse steps 1 through 4 to install the top cover, rear bezel, and handle brackets (securing
       the handles). NOTE: The screw removed in step 3 must be reinstalled to provide ground
       continuity to the cover. Failure to install this screw can allow voltages to be present on
       the cover, that under certain conditions could possibly cause bodily injury or death.

Mark Option on the Rear Panel

    8. Black the option 001 square on the rear panel to indicate the option is now installed.
Figure 1




Figure 2

               

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo