Service Manuals, User Guides, Schematic Diagrams or docs for : logitech Logitech_Modula-2_86_1.0_Feb84

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.




Image preview - the first page of the document
Logitech_Modula-2_86_1.0_Feb84


>> Download Logitech_Modula-2_86_1.0_Feb84 documenatation <<

Text preview - extract from the document
~LOGITECH

           mODULA 2/86


       on m/-dol (pc-dol)




LOGI'l'ECif SA - CB-1143 APFLES
Ph6ne (0)21 / 77 45 45    -   Telex 458 217   -   Fax (0)21 / 77 31 36
             ~   LOGITECH


Software Engineering Library
Modula-2/86, Release 1.0                          February 29, 1984

Release notes for release 1.0 on DOS 2.0

1) File handling in DOS 2.0
Modula-2/86 now internally uses DOS 2.0 calls for file operations.
For this reason you must have a file 'CONFIG.SYS' on the the
disk you use to start (boot) your DOS 2.0 system. This file must
at least contain the command
FILES=12
in order to set the maximum number of open files in DOS 2.0 to
twelve. This minimum is required for proper operation of the
Modula-2/86 system (compiler, linker, debugger). By default,
DOS 2.0 allows opening four files only, which is not sufficient
    operating Modula-2/86.
'-   ,,/
If the proper number of files is not set in DOS, then an error
message 'file not found' will appear when operating the Modula-2/86
compiler. While the file in question may be present, it cannot
be opened due to a lack of file descr~ptors in the operating system.
Also it is recommended that you set the number of buffers
to at least thirteen (not just eight as stated
in the manual). This can be achieved by the command
BUFFERS=13
which also goes in the file 'CONFIG.SYS'. While this is not required,
it will improve the performance of the Modula-2/86 system.
A sample 'CONFIG.SYS' file   is provided on your Modula-2/86
system diskette. After you   have changed or install~d your
'CONFIG.SYS' file, be sure   to re-start (boot) your operating
system, in order for these   changes to become effective.

'2) Installation
The Modula-2/86 system has been greatly improved for operating
with DOS 2.0. For the best installation please refer to chapter
F



◦ Jabse Service Manual Search 2020 ◦ Jabse Pravopis ◦ Other service manual resources online : FixyaeServiceinfo