Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Forester 1999-2004 Approved Subaru Forester 1999-2000 AUTOMATIC TRANSMISSION MSA5T0128A34683
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5T0128A34683 documenatation <<Text preview - extract from the document CENTER DIFFERENTIAL CARRIER
Automatic Transmission
15. Center Differential Carrier C : DISASSEMBLY 5510592A06
5510592
1) Remove seal ring.
A: REMOVAL S510592Ai8 CAUTION :
1) Remove rear vehicle speed sensor, and sepa- Be careful not to damage the seal rings.
rate the extension case form the transmission
case . [
2) Pull out the rear drive shaft. ][
3) Using ST, extract the center differential carrier
assembly.
ST1 499737100 PULLER
ST2 899524100 PULLER SET
(A) Seal rings
2) Using a press and ST, remove the ball bearing .
ST 498077000 REMOVER
4) Extract shim from transmission case .
B : INSTALLATION S510592A11
1) Install the center differential assembly with
shim .
NOTE:
Insert it fully into position until the bearing shoulder 3) Remove snap ring, and pull out shafts from
bottoms . center differential assembly.
2) Insert the rear drive shaft . (B) Shaft
3) Combine the transmission case with the exten-
sion case, and install rear vehicle speed sensor.
][
AT53
CENTER DIFFERENTIAL CARRIER
Automatic Transmission
4) Remove thrust washer, pinion gears and wash-
ers from center differential assembly .
(A)
0
H3M18668
(A) Pinion gear
5) Pull out intermediate shaft and thrust bearing.
D : ASSEMBLY S5,o59zAOz
1) Install thrust washer to intermediate shaft.
2) Install thrust bearing and intermediate shaft.
3) Install pinion gears and washers .
4) Put shaft in center differential assembly .
5) Install snap ring.
6) Using a press, press-fit the ball bearing to cen-
ter differential assembly .
ST 498077000 REMOVER
CAUTION:
Be sure to use a new ball bearing.
(A) Plate
(B) Center differential carrier
E : INSPECTION S5,o592A,o
Make sure that each component is free of harm-
ful gouges, cuts, or dust .
o Measure the extension end play and adjust it to
within specifications . ][
AT54
]
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo