Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Forester 1999-2004 Approved Subaru Forester 2004 5 - Body Lighting System Combination Switch (Light)

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download Combination Switch (Light) documenatation <<

Text preview - extract from the document

COMBINATION SWITCH (LIGHT)
LIGHTING SYSTEM

8. Combination Switch (Light) C: INSPECTION
Measure the combination switch resistance.
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
3) Remove the screws which secure upper column
cover to lower column cover.

(A)

8 7 6 5 4 3 2 1
17 16 15141312 11 10 9

LI-00009

4) Disconnect the connector from combination
(B)
switch. 2 1
5) Remove the screws which secure switch, and 4 3

then remove the switch.
LI-00052

(A) Lighting & turn signal switch connector
(B) Parking switch connector

1. LIGHTING SWITCH
Switch position Terminal No. Standard
OFF -- More than 1 M
Tail 14 and 16 Less than 1
LI-00068
Head 13, 14 and 16 Less than 1
B: INSTALLATION
Install in the reverse order of removal. 2. DIMMER AND PASSING SWITCH
Switch position Terminal No. Standard
Passing 7, 8 and 16 Less than 1
Low beam 16 and 17 Less than 1
High beam 7 and 16 Less than 1

3. TURN SIGNAL SWITCH
Switch position Terminal No. Standard
Left 1 and 2 Less than 1
Neutral -- More than 1 M
Right 2 and 3 Less than 1

4. PARKING SWITCH
Switch position Terminal No. Standard
OFF 2 and 4 Less than 1
ON 1 and 4 Less than 1

LI-9
HEADLIGHT ASSEMBLY
LIGHTING SYSTEM

9. Headlight Assembly B: INSTALLATION
Install in the reverse order of removal.
A: REMOVAL
1) Disconnect the ground cable from battery. C: ADJUSTMENT
2) Remove the air intake duct (when right side 1. HEADLIGHT AIMING
headlight is removed).
3) Remove the front grille and headlight side cover. NOTE:
is possible to adjust aiming only in the vertical di-
4) Disconnect the headlight bulb connector. rection. It cannot be adjusted in the horizontal di-
rection.
CAUTION:
Turn off the light before adjusting headlight
aiming. If the light is necessary to check aim-
ing, do not turn on for more than two minutes.
NOTE:
Before checking the headlight aiming, be sure of
the following:

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo