Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 2000-2003 Approved Subaru Legacy 2000 2000 Service Manual BODY SECTION Doors and Windows MSA5TCD00L15985
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD00L15985 documenatation <<Text preview - extract from the document SERVICE PROCEDURE [W7A2] 5-2
7. Rear Quarter Glass
7. Rear Quarter Glass
A: REMOVAL
1. SEDAN
Rear quarter glass Body panel
A
Matching pin
Matching pin Trim panel Matching pin
Section A B5M0819A
Remove glass in the same manner as in wind-
shield.
NOTE:
Matching pins are cemented at the glass corners
on the compartment side. Use a piano wire when
cutting each pin.
2. WAGON
1) Remove rear quarter molding on corner.
2) Remove glass in the same manner as in wind-
shield.
31
5-2 [W7B0] SERVICE PROCEDURE
7. Rear Quarter Glass
B: INSTALLATION 5) Application of adhesive:
(1) Cut nozzle tip as shown in figure.
1) Finish surface of adhesive layer on body:
Using a putty knife, etc., cut layer of adhesive stick
firmly to body and finish it into a smooth surface of
about 2 mm (0.08 in) in thickness.
CAUTION:
Be careful not to damage body finish.
G5M0414
(2) Open cartridge and put it into a gun with
nozzle attached.
(3) Apply adhesive uniformly to all sides of
adhesion surface while operating gun along
glass end face.
G5M0497 6) Installation of glass:
(1) Hold glass with rubber suction cups.
2) Cleaning of body surface:
(2) Mount glass on body with matching pin
(1) Remove chips, dirt and dust from body sur- aligned.
face. (3) Stick them fast by pressing all sides lightly.
(2) Clean body wall surface and upper surface 7) Water leakage test:
of adhesive layer with a solvent such as alcohol After installing glass, test for water leakage after
or white gasoline. about one hour.
3) Cleaning glass:
(1) Remove dirt and dust from surface of glass CAUTION:
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo