Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 2000-2003 Approved Subaru Legacy 2000 2000 Service Manual GENERAL INFORMATION SECTION Pre Delivery Inspection MSA5TCD00L17418<< Back
| HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD00L17418 documenatation <<Text preview - extract from the document
PRE-DELIVERY INSPECTION [G2O1] 1-4
2. Pre-road Test Inspection
N: COOLANT LEVEL AND COOLING O: ENGINE OIL LEVEL
FAN INSTALLATION CHECK POINTS
CHECK POINTS 1. Engine oil level
1. Coolant level 2. Engine oil leakage or contamination
2. Cooling fan motor and wiring 1. CHECK THE ENGINE OIL LEVEL
3. Water leakage and hose damage
The level should be within the specified range
WARNING: marked on the gauge.
The radiator is a high pressure type. Never
attempt to open the radiator cap when the
coolant's temperature is high; otherwise
boiling water will spurt out. Be sure to wait
until the engine cools down before opening
the radiator cap.
D The level must be kept at "FULL" level.
D Use only genuine SUBARU Coolant (P/N
D Avoid using any coolant or only water oth-
er than this designated type to prevent cor- G1H0397
D When retightening the hose clamps, be
careful not to over-tighten them, as doing so NOTE:
could damage the hose. D Check engine oil level before starting the en-
gine, when engine oil is cold, to obtain correct
NOTE: level reading. After stopping a hot engine, wait
D Always inspect and add at reserve tank when about 5 minutes until oil returns to oil pan before
engine is cold. checking oil level. Oil level reading will be
D If reserve tank is empty, check coolant level slightly higher than when engine is cold due to
in radiator. Add coolant up to filler neck of radia- oil expansion. It is advisable to check oil level
tor too, if necessary. each time oil is replenished.
D Insert the oil level gauge into guide hole.
API classification: SJ or SH with the
words "Energy Conserving or Energy
Conserving II", CCMC specification G4
or G5, ACEA specification A1, A2 or A3,
or New API mark displayed on the con-
tainer (If it is impossible to get SJ or SH
grade, you may use SG grade.)
◦ Jabse Service Manual Search 2020 ◦ Jabse Pravopis ◦ Other service manual resources online : Fixya ◦ eServiceinfo