Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 2000-2003 Approved Subaru Legacy 2000 2000 Service Manual TRANSMISSION AND DIFFERENTIAL SECTION Transmission Control System MSA5TCD00L18832

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download MSA5TCD00L18832 documenatation <<

Text preview - extract from the document
3-3  [W1A0]                       SERVICE PROCEDURE
1. Gear Shift Lever

1. Gear Shift Lever                                6) Remove gear shift lever.

1) Remove console box. 
2) Remove plate from the body.


                                                   B: DISASSEMBLY
                                                   1) Disconnect locking wire (A).

3) Remove stay from bracket.


                                                   2) Remove rod (A) from lever.

4) Remove rod (A) from joint.


                                   B3M0616B        3) Remove snap ring (A) from bush (B), then dis-
                                                   connect lever from stay.
5) Remove the exhaust cover and remove cush-       4) Remove boot (C) from lever.
ion rubber (A) from the body.


                                   SERVICE PROCEDURE                                      [W1D0] 3-3
                                                                                      1. Gear Shift Lever

5) Remove O-ring (A), then disconnect bush (Stay       C: INSPECTION
rear) (B).
                                                       Check each parts (Bush (A), cushion (B), spacer
                                                       (C), boot (D), stay (E) and rod (F) etc.) for
                                                       deformation, damage and wear. Repair or replace
                                                       any defective parts. Determine defective parts by
                                                       comparing with new parts.


6) Draw out spring pin (A), then remove bush
(Shift lever) (B) from lever.



                                                       D: ASSEMBLY
                                                       1) Clean all parts before assembly.
                                                       2) Mount the bush (Stay front) (A) and cushion
                                                       rubber (B) on the stay.


3-3  [W1E0]                          SERVICE PROCEDURE
1. Gear Shift Lever

3) Mount each parts (Boot (A), O-ring (B), bush           7) Tighten with locking wire (A) to the extent that
(C), spacer (D), bush (Shift lever) (E), bush (Stay       the boot will not come off.
rear) (F) and spring pin (G)) on the lever.               CAUTION:
CAUTION:                                                  Always use new locking wire.

◦ Jabse Service Manual Search 2021 ◦ Jabse ◦ Other service manual resources online : FixyaeServiceinfo