Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Echo 2000-2002 Approved techinfo.toyota.com ileaf 02toyrm 02toypdf 02rmsour 2002 02echorm br fbp repl
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download repl documenatation <<Text preview - extract from the document BR-19
BRAKE - FRONT BRAKE PAD
BR11D-02
REPLACEMENT
1. REMOVE FRONT WHEEL
2. INSPECT PAD LINING THICKNESS
Check the pad thickness through the caliper inspection hole
and replace the pads if they are not within the specification.
Minimum thickness: 1.0 mm (0.039 in.)
F07789
3. LIFT UP CALIPER
(a) Hold the sliding pin on the bottom and loosen the installa-
tion bolt, and remove the installation bolt.
(b) Lift up the caliper and suspend it securely.
HINT:
Do not disconnect the flexible hose from the caliper.
4. REMOVE BRAKE PADS WITH ANTI-SQUEAL SHIMS
5. REMOVE 2 PAD SUPPORT PLATES
F07790 NOTICE:
The support plates can be used again provided that they
have sufficient rebound, no deformation, cracks or wear,
and have had all rust, dirt and foreign particles cleaned off.
6. CHECK DISC THICKNESS AND RUNOUT
(See page BR-24 )
7. INSTALL 2 PAD SUPPORT PLATES
8. INSTALL NEW PADS
NOTICE:
When replacing worn pads, the anti-squeal shims and pad
wear indicator plates must be replaced together with the
pads.
(a) Apply disc brake grease to the anti-squeal shims (See
page BR-21 ).
(b) Install the 2 anti-squeal shims on the outer pad.
(c) Install the 2 anti-squeal shims on the inner pad.
(d) Install the inner pad with the pad wear indicator plate fac-
ing upward.
(e) Install the outer pad.
NOTICE:
There should be no oil or grease adhering to the friction
surfaces of the pads or the disc.
9. INSTALL CALIPER
(a) Draw out a small amount of brake fluid from the reservoir.
(b) Press in the piston with a hammer handle or similar imple-
ment.
HINT:
If the piston is difficult to push in, loosen the bleeder plug and
push in the piston while letting some brake fluid escape.
(c) Install the caliper.
F08580 (d) Hold the sliding pin and install the installation bolt.
Torque: 34 N
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo