Service Manuals, User Guides, Schematic Diagrams or docs for : Stanford Research Systems www.thinksrs.com-SR245_GPIB

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document
www.thinksrs.com-SR245_GPIB


>> Download www.thinksrs.com-SR245_GPIB documenatation <<

Text preview - extract from the document
Instructions for using National Instrument
Measurement & Automation Explorer with
      the SR245 Computer Interface
          These instructions are for the default GPIB address of 25.

    If using a National Instruments GPIB-USB-HS then you need to
 connect a standard GPIB cable (at least 1.5 meters in length) in between
            the National instruments connector and the SR245


 1.   Setup the SR245 for GPIB communication (see manual page 41).
 2.   Start up Measurement & Automation Explorer
 3.   Select the + box next to "Devices and Interfaces"
 4.   Select "GPIB0 (GPIB-USB-HS)" or (PCI-GPIB)
 5.   On the upper menu click on "Scan for Instruments"
 6.   Double click on the instrument with address 25 (Bottom of the page
      section labeled "Connected Instruments"




 7.
8. Select "Communicate with Instrument" on the top menu




9. Power up/down the mainframe (*idn? is an invalid command that
   locks up the SR245 for the first command)
10.Select "Configure EOS"




11.Type 10 in the EOS Byte box and hit "OK".

(ALL COMMANDS SENT TO THE SR245 MUST END WITH A "\r")

12.In the "Send String" dialog box type: i2\r and then click on the
   "Write" button (This sets the first two ports as inputs and the
   remaining ports as outputs). The ACTIVITY light on the SR245
   should blink the ERROR light should not.
13.Type: s4=3.3\r then the Write button (This sets the output voltage
   on port 4 to 3.3V). You might want to check it with a meter.
14.Type: ?4\r then the Querry button (This queries the port)
15.The "String Received" box should return the value of port 4.



◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo