Service Manuals, User Guides, Schematic Diagrams or docs for : Tektronix 7A18, 7A18N Dual Trace Amplifier
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download 7A18, 7A18N Dual Trace Amplifier documenatation <<
Text preview - extract from the document
INSTRUCTION
IAi8/tA"%H
DUAL TRACE
AMPLIFIER
7A18
7A18
TABLE OF CONTENTS
SECTION 1 SPECIFICATION Page OPTION INFORMATION
lntroduction I- I
Electrical Characteristics 1-1 SECTION 6 ELECTRICAL PARTS LIST
7A18 And Mainframe Frequency
Abbreviations and Symbols
Response 1-3
Environmental Characteristics 1-3 Parts Ordering lnformation
Physical Characteristics 1-3
SECTION 7 DIAGRAMS AND CIRCUIT BOARD
SECTION 2 OPERATING INSTRUCTIONS ILLUSTRATIONS
Installation 2-1 Symbols and Reference Designators
Front Panel Controls and Connectors 2-1
Voltage and Waveform Conditions
General Operating Information 2-2
Basic Applications 2-4
SECTION 3 CIRCUIT DESCRiPTlON
SEC'TION 8 MECHANICAL PAR1'S LIST
Introduction 3-1
3-1 Mechanical Parts List Information
Block Diagram Description
Detailed Circuit Description 3-1 Index of Mechanical Parts Illustrations
Mechanical Parts List
SECTION 4 MAINTENANCE Accessories
Preventive Maintenance
Troubleshooting
Replacement Parts 4-3 CHANGE INFORMATION
Component Replacement 4-4
SECTION 5 CALIBRATION
Abbreviations and symbols used i n this manual are based on
Recalibration Interval 5-1 or taken directly from IEEE Standard 260 "Standard
'Test Equipment Required 5-1 Symbols for Units", MIL-STD-12B and other standards o f .
Part I -.-Performance Check 5-3 the electronics industry. Change information, if any, i s
Part I I - Adjustment 5-7 located at the rear of this manual.
REV. JUNE 1974
7A18
7A18
Change information, i f any, affecting this section will be found at the rear of the manual.
t ntroduction the setting of the VOL-I"S/DIV switch. Channel 2 can be
inverted for differential measurements. The 7A18 can be
The 7A18 and 7A18N Dual Trace Amplifier plug-in operated in any plug-in compartment of the 7000-Series
units are designed for use with l-ektronix 7000-Series Oscilloscopes.
Oscilloscopes. The 7A18 and 7A18N are electrically iden-
tical except that readout encoding capabilities and an
"IDENTIFY" function are provided only in the 7A18. All
references made t o the 7A18 apply equally t o the 7A18N The following electrical characteristics are valid over the
unless othewise noted. The 7A18 is a dual-channel, stated environmental range for instruments calibrated at an
medium-bandwidth amplifier. Internal gain and compensa- ambient temperature of i - 2 0 " ~ +30◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo