Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Nissan Micra 2003-2006 Approved 03k12e ACC
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download ACC documenatation <<
Text preview - extract from the document
ACCELERATOR CONTROL SYSTEM
B ENGINE
A
ACC
SECTION
ACCELERATOR CONTROL SYSTEM C
D
E
CONTENTS
ACCELERATOR CONTROL SYSTEM ..................... 2 . SERVICE DATA AND SPECIFICATIONS (SDS) ....... 3 . F
Removal and Installation ......................................... 2
. Tightening Torque .................................................... 3
.
REMOVAL ............................................................ 2
.
INSTALLATION .................................................... 2
. G
INSPECTION AFTER INSTALLATION ................ 2 .
H
I
J
K
L
M
ACC-1
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM PFP:18005
Removal and Installation EBS00OJF
PBIC1506E
Accelerator pedal stopper
1. Accelerator pedal assembly 2.
(Underfloor carpet)
REMOVAL
1. Remove harness connector.
2. Remove mounting bolts, and remove accelerator assembly.
CAUTION:
q Do not disassemble accelerator pedal assembly and remove sensors.
q Handle them carefully without subjecting them to impacts such as dropping.
q Be careful not to get it wet.
3. Fold the floor carpet and remove accelerator pedal stopper.
q Remove pedal stopper by turning it counterclockwise with fingers.
INSTALLATION
Install in the reverse order of removal. be careful of the following:
q Insert locating pin into vehicle side to position accelerator pedal assembly. Install mounting bolt to acceler-
ator pedal assembly.
q Align the stud bolt on the floor with the thread hole to insert accelerator pedal stopper until it contacts the
face.
INSPECTION AFTER INSTALLATION
q Check that the accelerator pedal moves smoothly within the whole operation range.
q Check that the accelerator pedal securely returns to the original position.
q For the electrical inspection of the accelerator pedal assembly, refer to EC-233, "DTC P0226 APP SEN-
SOR" (CR WITH EURO-OBD), EC-621, "DTC P0226 APP SENSOR" (CR WITHOUT EURO-OBD) or
"Interpretation", "DIESEL INJECTION" in EC section(K9K).
q When accelerator electrical connector is disconnected, perform EC-42, "Accelerator Pedal Released
Position Learning" (WITH EURO-OBD), EC-503, "Accelerator Pedal Released Position Learning"
(WITHOUT EURO-OBD).
ACC-2
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS) PFP:00030
A
Tightening Torque EBS00OJG
Unit: N◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo