Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Nissan Rogue 2008-2009 Approved Nissan Rogue 2009 CHG
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download CHG documenatation <<Text preview - extract from the documentELECTRICAL & POWER CONTROL
A
SECTION CHG
CHARGING SYSTEM
B
C
D
E
CONTENTS
BASIC INSPECTION ................................... 2
. PRECAUTION ............................................. 16
. F
DIAGNOSIS AND REPAIR WORKFLOW ......... 2
. PRECAUTIONS ................................................. 16
Work Flow ................................................................ 2
. G
FOR USA AND CANADA .........................................16
.
FUNCTION DIAGNOSIS .............................. 5
. FOR USA AND CANADA : Precaution for Supple-
mental Restraint System (SRS) "AIR BAG" and
CHARGING SYSTEM ......................................... 5
. "SEAT BELT PRE-TENSIONER" ...........................16. H
System Diagram ....................................................... 5
.
System Description .................................................. 5
. FOR MEXICO ............................................................16
.
Component Parts Location ....................................... 5
. FOR MEXICO : Precaution for Supplemental Re-
straint System (SRS) "AIR BAG" and "SEAT BELT I
Component Description ........................................... 6
.
PRE-TENSIONER" .................................................16.
COMPONENT DIAGNOSIS ......................... 7
.
PREPARATION .......................................... 17
. J
B TERMINAL CIRCUIT ...................................... 7
.
Description ............................................................... 7
. PREPARATION ................................................. 17
Diagnosis Procedure ................................................ 7
. Special Service Tools .............................................17
.
Commercial Service Tools ......................................17
. K
L TERMINAL CIRCUIT (OPEN) ......................... 8
.
Description ............................................................... 8
. ON-VEHICLE MAINTENANCE ................... 18
.
Diagnosis Procedure ................................................ 8
. L
CHARGING SYSTEM PRELIMINARY IN-
L TERMINAL CIRCUIT (SHORT) ......................10
. SPECTION ........................................................ 18
Description ............................................................. 10
. Inspection Procedure ..............................................18
.
CHG
Diagnosis Procedure .............................................. 10.
ON-VEHICLE REPAIR ................................ 19
.
S TERMINAL CIRCUIT .....................................11
.
Description ............................................................. 11
. ALTERNATOR .................................................. 19 N
Diagnosis Procedure .............................................. 11. Exploded View ........................................................19
.
Removal and Installation ........................................20 .
CHARGING SYSTEM ........................................12
. Inspection ...............................................................21
.
Wiring Diagram - CHARGING SYSTEM - .............. 12
. O
SERVICE DATA AND SPECIFICATIONS
SYMPTOM DIAGNOSIS ............................. 15
. (SDS) ........................................................... 22
.
P
CHARGING SYSTEM ........................................15
. SERVICE DATA AND SPECIFICATIONS
Symptom Table ...................................................... 15
. (SDS) ................................................................. 22
Alternator ................................................................22
.
Revision: 2008 August CHG-1 2009 Rogue
DIAGNOSIS AND REPAIR WORKFLOW
< BASIC INSPECTION >
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow INFOID:0000000004233775
OVEROALL SEQUENCE
JPMIA0624GB
DETAILED FLOW
Revision: 2008 August CHG-2 2009 Rogue
DIAGNOSIS AND REPAIR WORKFLOW
< BASIC INSPECTION >
NOTE:
To ensure a complete and thorough diagnosis, the battery, starter and alternator test segments must be done A
as a set from start to finish.
1.PRELIMINARY INSPECTION
B
Perform the preliminary inspection. Refer to CHG-18, "Inspection Procedure".
>> GO TO 2.
C
2.DIAGNOSIS WITH STARTING/CHARGING SYSTEM TESTER
Perform the charging system test using Starting/Charging System Tester (SST: J-44373). For details and oper-
ating instructions, refer to Technical Service Bulletin. D
Test result
CHARGING SYSTEM NOMAL>>Charging system is normal and will also show "DIODE RIPPLE" test result.
NO CHARGING VOLTAGE>>GO TO 3. E
LOW CHARGING VOLTAGE>>GO TO 11.
HIGH CHARGING VOLTAGE>>GO TO 13.
DIODE RIPPLE NORMAL>>Diode ripple is OK and will also show "CHARGING VOLTAGE" test result. F
EXCESS RIPPLE DETECTED>>Replace the alternator. Perform "DIODE RIPPLE" test again using Starting/
Charging System Tester (SST: J-44373) to confirm repair.
DIODE RIPPLE NOT DETECTED>>GO TO 4.
G
3.INSPECTION WITH CHARGE WARNING LAMP (IGNITION SWITCH IS ON)
Turn the ignition switch ON.
Does the charge warning lamp illuminate? H
YES >> GO TO 5.
NO >> GO TO 4.
4."L" TERMINAL CIRCUIT (OPEN) INSPECTION I
Check "L" terminal circuit (open). Refer to CHG-8, "Diagnosis Procedure".
Is the "L" terminal circuit normal? J
YES >> Replace alternator.
NO >> Repair as needed.
5.INSPECTION WITH CHARGE WARNING LAMP (IDLING) K
Start the engine and run it at idle.
Does the charge warning lamp turn OFF?
L
YES >> GO TO 8.
NO >> GO TO 6.
6."L" TERMINAL CIRCUIT (SHORT) INSPECTION CHG
Check "L" terminal circuit (short). Refer to CHG-10, "Diagnosis Procedure".
Is the "L" terminal circuit normal?
YES >> GO TO 7. N
NO >> Repair as needed.
7."S" TERMINAL CIRCUIT INSPECTION
O
Check "S" terminal circuit. Refer to CHG-11, "Diagnosis Procedure".
Is the "S" terminal circuit normal?
YES >> GO TO 9. P
NO >> Repair as needed.
8.INSPECTION WITH CHARGE WARNING LAMP (ENGINE AT 3,000 RPM)
Increase and maintain the engine speed at 3,000 rpm.
Does the charge warning lamp remain off?
YES >> GO TO 10.
NO >> GO TO 9.
Revision: 2008 August CHG-3 2009 Rogue
DIAGNOSIS AND REPAIR WORKFLOW
< BASIC INSPECTION >
9.INSPECTION OF ALTERNATOR PULLEY
Check alternator pulley. Refer to CHG-21, "Inspection".
Is alternator pulley normal?
YES >> Replace alternator.
NO >> Repair as needed.
10."B" TERMINAL CIRCUIT INSPECTION
Check "B" terminal circuit. Refer to CHG-7, "Diagnosis Procedure".
Is "B" terminal circuit normal?
YES >> Replace alternator.
NO >> Repair as needed.
11."B" TERMINAL CIRCUIT INSPECTION
Check "B" terminal circuit. Refer to CHG-7, "Diagnosis Procedure".
Is "B" terminal circuit normal?
YES >> GO TO 12.
NO >> Repair as needed.
12.INSPECTION OF ALTERNATOR PULLEY
Check alternator pulley. Refer to CHG-21, "Inspection".
Is alternator pulley normal?
YES >> Replace alternator.
NO >> Repair as needed.
13."S" TERMINAL CIRCUIT INSPECTION
Check "S" terminal circuit. Refer to CHG-11, "Diagnosis Procedure".
Is the "S" terminal circuit normal?
YES >> Replace alternator.
NO >> Repair as needed.
Revision: 2008 August CHG-4 2009 Rogue
CHARGING SYSTEM
< FUNCTION DIAGNOSIS >
FUNCTION DIAGNOSIS A
CHARGING SYSTEM
System Diagram INFOID:0000000004233776
B
C
D
E
F
G
H
I
JPMIA0426GB
J
System Description INFOID:0000000004233777
The alternator provides DC voltage to operate the vehicle's electrical system and to keep the battery charged.
The voltage output is controlled by the IC voltage regulator. K
Component Parts Location INFOID:0000000004233778
L
CHG
N
O
P
JPMIA0274ZZ
1. Battery 2. Alternator 3. Charge warning lamp
A. Engine room (left side) B. Engine C. Combination meter
Revision: 2008 August CHG-5 2009 Rogue
CHARGING SYSTEM
< FUNCTION DIAGNOSIS >
Component Description INFOID:0000000004233779
Component part Description
"B" terminal Refer to CHG-7, "Description".
Alternator "S" terminal Refer to CHG-11, "Description".
"L" terminal Refer to CHG-8, "Description".
The IC voltage regulator warning function activates to illuminate
the charge warning lamp, if any of the following symptoms occur
Combination meter (Charge warning lamp) while alternator is operating:
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo