Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Forester 1999-2004 Approved Subaru Forester 1999-2000 BODY AND ELECTRICAL SECTION Body Electrical System MSA5T0126A27947
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5T0126A27947 documenatation <<Text preview - extract from the document6-2 [W4C2] SERVICE PROCEDURE
5. Front Wiper and Washer
2. HEADLIGHT RELAY 5. Front Wiper and Washer
Check continuity between terminals when terminal
No. 4 is connected to battery and terminal No. 3 is
A: ADJUSTMENT
grounded. 1) Turn the wiper switch to OFF position.
2) Adjust so that the blades meet the ceramic print
When current Between terminals point mark (A).
Continuity exists.
flows No. 1 and No. 2
Between terminals Continuity does not
When current No. 1 and No. 2 exist.
does not flow Between terminals
Continuity exists.
No. 3 and No. 4
S6M0049B
3) Adjust washer ejecting area on windshield
glass as shown in the figure when vehicle stops.
Ejecting area:
S6M0048B A: 350 mm (13.78 in)
B: 100 mm (3.94 in)
3. TAIL AND ILLUMINATION RELAY C: 60 mm (2.36 in)
Check continuity between terminals (indicated in
table below) when terminal No. 4 is connected to
battery and terminal No. 3 is grounded.
When current Between terminals
Continuity exists.
flows No. 1 and No. 2
Between terminals Continuity does not
When current No. 1 and No. 2 exist.
does not flow Between terminals
Continuity exists.
No. 3 and No. 4
B6M1315A
S6M0048B
8
SERVICE PROCEDURE [W5B3] 6-2
5. Front Wiper and Washer
B: REMOVAL AND INSTALLATION 3) Disconnect electric connector, and remove
motor attaching bolts.
1. BLADE
Tightening torque:
1) Pull out blade following the arrow direction, 5.9
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo