Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Forester 1999-2004 Approved Subaru Forester 1999-2000 BODY AND ELECTRICAL SECTION Engine Electrical System MSA5T0126A27937

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download MSA5T0126A27937 documenatation <<

Text preview - extract from the document

6-1   [W2D0]                         SERVICE PROCEDURE
3. Spark Plug


  (3) Set a new bearing and closely install a fit          3. Spark Plug
  tool on the bearing outer race. Press the bear-
  ing down into place with a hand press or vise.           A: REMOVAL AND INSTALLATION
  A socket wrench can serve as the tool.
  (4) Install front bearing retainer.                      CAUTION:
                                                           All spark plugs installed on an engine, must be
                                                           of the same heat range.
                                                           Spark plug:
                                                               CHAMPION: RC10YC4
                                                             (Alternate)
                                                               CHAMPION: RC8YC4
                                                               NGK: BKR6E-11
                                                               NIPPONDENSO: K20PR-U11
                                                           1. #1 SPARK PLUG
                                       S6M0410A            1) Disconnect battery ground cable.
   (A)   Bearing
   (B)   Socket wrench
   (C)   Front bracket

D: ASSEMBLY
Assemble in the reverse order of disassembly.
1) Pulling up brush
Before assembling, press the brush down into the
brush holder with your finger and secure in that
position by passing a [2 mm (0.08 in) dia. length 4
                                                                                                 G6M0095
to 5 cm (1.6 to 2.0 in)] wire (A) through the hole
shown in the figure.                                       2) Remove air intake duct and resonator chamber.
CAUTION:                                                      (1) Remove bolt which installs air intake duct
Be sure to remove the wire after reassembly.                  on the front side of body.




                                       S6M0411A                                                   S6M0708

2) Heat the bearing box in the rear bracket [50 to           (2) Remove bolt which installs air intake duct
60

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo