Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1995 1995 Service Manual ELECTRICAL SECTION BODY ELECTRICAL SYSTEM MSA5TCD95L5853
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD95L5853 documenatation <<
Text preview - extract from the document
SERVICE PROCEDURE 6-2
17. Power Door Lock
17. Power Door Lock
A: REMOVAL AND INSTALLATION
1. FRONT AND REAR DOOR, AND REAR GATE LOCK
ACTUATOR
Refer to 5-2 [W2A7] as for removal and installation of front
door lock actuator, rear door lock actuators, and rear gate
lock actuator.
NOTE:
To remove and install the actuators, it is necessary to dis-
assemble the door component parts.
2. DOOR LOCK TIMER
1) Remove glove box.
2) Remove back pocket cover.
3) Remove two bolts located at the rear of back pocket
cover.
4) Remove instrument panel side right cover and bolt.
5) Remove clip located at the inside end of instrument
panel.
6) Remove nut which secures door lock timer, and remove
B6M0351A door lock timer from bracket while pulling right side lower
end of instrument panel.
CAUTION:
Be careful not to damage instrument panel while pull-
ing its right side lower end.
7) Disconnect connector from door lock timer.
8) Installation is in the reverse order of removal.
41
6-2 SERVICE PROCEDURE
17. Power Door Lock - 18. Remote Controlled Rearview Mirror
B: INSPECTION
1. DOOR LOCK SWITCH (DRIVER'S DOOR)
1) Remove door trim panel.
2) Disconnect connector of door switch.
3) Set switch to each position and check continuity
between terminals as indicated in table below:
Terminal
1 2
Switch position
B6M0133 UNLOCK k k
LOCK
2. ACTUATOR
1) Remove door trim panel.
2) Disconnect connector of actuator.
3) Make sure that door link moves to LOCK or UNLOCK
position when battery voltage is applied between terminals
as described below:
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo