Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1996 1996 Service Manual MECHANICAL COMPONENTS SECTION STEERING SYSTEM MSA5TCD96L6178

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download MSA5TCD96L6178 documenatation <<

Text preview - extract from the document

SERVICE PROCEDURE                                             4-3
                                           10. Power Steering Fluid


    10. Power Steering Fluid
    A: RECOMMENDED AIR BLEEDING AND
    POWER STEERING FLUID
       Recommended power steering fluid        Manufacturer
                                                   B.P.
                                                 CALTEX
                                                CASTROL
      ATF DEXRON II or ATF DEXRON IIE
                                                  MOBIL
                                                 SHELL
                                                TEXACO

    1) Feed the specified fluid with its level being about 5 cm
    (2.0 in) lower than the mouth of tank.
    2) Continue to turn steering wheel slowly from lock to lock
    until bubbles stop appearing in the tank while keeping the
    fluid at that level.
    3) In case air is absorbed to deliver bubbles into piping
    because the fluid level is lower, leave it about half an hour
    and then do the step 2) all over again.
    4) Start, and idle the engine.
    5) Continue to turn steering wheel slowly from lock to lock
    again until bubbles stop appearing in the tank while keep-
    ing the fluid at that level.
    It is normal that bubbles stop appearing after three times
    turning of steering wheel.
    6) In case bubbles do not stop appearing in the tank, leave
    it about half an hour and then do the step 5) all over again.
    7) Stop the engine, and take out safety stands after jack-
    ing up vehicle again.
    Then lower the vehicle, and idle the engine.
    8) Continue to turn steering wheel from lock to lock until
    bubbles stop appearing and change of the fluid level is
    within 3 mm (0.12 in).
    9) In case the following happens, leave it about half an
    hour and then do step 8) again.
         (1) The fluid level changes over 3 mm (0.12 in).
         (2) Bubbles remain on the upper surface of the fluid.
         (3) Grinding noise is generated from oil pump.




          81
4-3                          SERVICE PROCEDURE
10. Power Steering Fluid


                                     10) Check the fluid leakage at flare nuts after turning
                                     steering wheel from lock to lock with engine running.
                                     CAUTION:
                                     

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo