Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1997 1997 Service Manual ENGINE SECTION FUEL SYSTEM MSA5TCD97L3529

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download MSA5TCD97L3529 documenatation <<

Text preview - extract from the document

2-8 SERVICE PROCEDURE
3. Fuel Tank - 4. Fuel Filler Pipe

6) Install rear differential assembly.

G3M0059

7) Install muffler assembly.

G2M0384

8) Install heat sealed cover.
9) Install rear exhaust pipe.

G2M0382

10) Lower the vehicle, and connect connector to fuel
pump.
11) Install access hole lid.

G2M0340

4. Fuel Filler Pipe
A: REMOVAL
1) Release fuel pressure.
2) Drain fuel from fuel tank.

G2M0345

16
SERVICE PROCEDURE 2-8
4. Fuel Filler Pipe

3) Remove right rear wheel.
4) Open fuel filler flap and remove filler cap.
5) Remove screws holding packing in place.

G2M0360

6) Lift-up the vehicle.
7) Remove fuel filler pipe protector.

G2M0361

8) Remove clip, and separate air vent hose from pipe.
9) Loosen clamp, and separate fuel filler hose from pipe.
k Fuel filler hose
1
k Air vent hose
2
10) Remove fuel filler pipe to under side of the vehicle.

G2M0353

B: INSTALLATION
1) Hold fuel filler flap open.
2) Set fuel saucer k with rubber packing k , and insert fuel
1 3
filler pipe into hole from the inner side of apron.
3) Align holes in fuel filler pipe neck and set cup k , and
2
tighten screws.
NOTE:
If edges of rubber packing are folded toward the inside,
straighten it with a screwdriver.
G2M0364

4) Insert fuel filler hose approximately 25 to 30 mm (0.98
to 1.18 in) over the lower end of fuel filler pipe and tighten
clamp.
k Fuel filler hose
1
k Air vent hose
2
CAUTION:
Do not allow clips to touch air vent hose and rear sus-
pension crossmember.
G2M0353

17
2-8 SERVICE PROCEDURE
4. Fuel Filler Pipe - 5. Fuel Filter

5) Insert air vent hose approximately 25 to 30 mm (0.98 to
1.18 in) into the lower end of air vent pipe and hold clip.
k Hose
1
k Clip
2
k Pipe
3
L = 25 -- 30 mm (0.98 -- 1.18 in)

G2M0358

6) Install fuel filler pipe protector.
7) Install right rear wheel.

G2M0361

5. Fuel Filter
A: REMOVAL
1) Release fuel pressure.

2) Disconnect fuel delivery hoses from fuel filter.
3) Remove filter from holder.

G2M0347

B: INSPECTION
1) Check the inside of fuel filter for dirt and water sedi-
ment.
2) If it is clogged, or if replacement interval has been
reached, replace it.
3) If water is found in it, shake and expel the water from
inlet port.

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo