Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1997 1997 Service Manual MECHANICAL COMPONENTS SECTION PEDAL SYSTEM AND CONTROL CABLES MSA5TCD97L3719

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document
MSA5TCD97L3719


>> Download MSA5TCD97L3719 documenatation <<

Text preview - extract from the document
   SERVICE PROCEDURE                                                  4-5
                                                  1. Pedal - 2. Clutch Cable


           5) Move clevis pin to the left and then to the right. It should
           move without resistance while it is rattling. If resistance is
           felt, repeat adjustment procedures again from the begin-
           ning.




           6) Push release lever until operating cylinder push rod
           retracts. Ensure that clutch fluid level in reservoir tank
           increases. If clutch fluid level increases, hydraulic clutch is
           properly adjusted; if fluid level does not increase or push
           rod does not retract, replace master cylinder with new one.
           



B4M1191A


           2. Clutch Cable
           A: REMOVAL
           1) Disconnect clutch cable from release lever.




           2) Depress clutch pedal to the floor.
           3) Remove clutch cable clamp from pedal bracket.
           4) Disconnect clutch cable from pedal bracket and pedal
           end.
           5) Remove clutch cable from body.
           CAUTION:
           Before removing clutch cable from toe board, remove
           grommet. Slowly remove clutch cable, being careful
           not to scratch it.
B4M0160A


           B: INSTALLATION
           1) Clean clutch pedal fitting hole, and apply grease. Con-
           nect clutch cable to clutch pedal.
           2) Fit clutch pedal to pedal bolt, and connect clutch cable
           to bracket with clamp.
           3) Connect clutch cable end to pedal end.
           4) Connect clutch cable from release lever.
           5) Install grommet to toe board.
           6) Adjustment after cable installation.
G4M0332    

                 17



◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo