Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual BODY SECTION BODY AND EXTERIOR MSA5TCD98L21214

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.




Image preview - the first page of the document
MSA5TCD98L21214


>> Download MSA5TCD98L21214 documenatation <<

Text preview - extract from the document
5-1   [W15A0]                         SERVICE PROCEDURE
15. Roof Rail


15. Roof Rail                                               16. Sunroof
A: REMOVAL AND INSTALLATION                                 A: REMOVAL AND INSTALLATION
1) Remove roof trim, rear quarter trim, pillar trim,        1. SEDAN AND WAGON REAR (EXCEPT
etc.                                   OUTBACK)
2) Remove flange bolts.
3) Remove flange nuts.                                      1) Glass lid assembly:
4) Remove roof rail.                                           (1) Completely open sun shade. (Push it back
                                                               far.)
                                                               (2) Remove a clip and detach guide rail cover.
                                                               (3) Remove six nuts from the left and right lid
                                                               bracket.
                                                               (4) Working inside, slightly raise glass lid
                                                               assembly until it is disengaged from lid bracket.




                                         B5M0304

5) Installation is in the reverse order of removal.
CAUTION:
To prevent deformation, be sure to install roof
rail in steps 4), 3), 2) and 1), in that order.
                                                                                                    B5M0307A

                                                               (5) Hold both ends of glass lid assembly and
                                                               remove it at an angle.
                                                               (6) Installation is in the reverse order of
                                                               removal.
                                                            2) Sunroof motor and relay:
                                                               (1) Remove center pillar trim upper. 
                                                               (2) Remove front pillar trim upper. 
                                                               (3) Remove assist grip on left side.
                                                               (4) Remove sunvisor with hook.
                                                               (5) Remove sunroof switch.
                                                               (6) Remove rearview mirror.
                                                               (7) While rolling up roof trim, disconnect har-
                                                               ness clips and connector.
                                                               (8) While rolling up roof trim, remove spot lamp
                                                               bracket and sunroof motor.
                                                               (9) Installation is in the reverse order of
                                                               removal.




                                                                                                    B5M0308B



                                                       54
                                     SERVICE PROCEDURE                                       [W16A2] 5-1
                                                                                               16. Sunroof


3) Sunroof frame:                                           (8) Remove set bracket mounting bolts.
   (1) Remove sunroof switch, center and rear               (9) Remove sunroof frame.
   room lamps.
   (2) Remove roof trim, rear quarter trim, pillar
   trim, etc. 
   (3) Remove glass lid assembly.
   (4) Remove two harness support clips.




                                                                                                B5M0382A

                                                            (10) Installation is in the reverse order of
                                                            removal.
                                                          2. WAGON FRONT (OUTBACK)
                                      B5M0310A
                                                          1) Sunroof panel:
  (5) Disconnect harness clips and connector of              (1) Tilt up the front sunroof (Most upper posi-
  sunroof motor.                                             tion).
  (6) Disconnect front and rear drain tubes.                 (2) Disconnect ground cable from battery.
CAUTION:                                                     (3) Remove sunroof switch then remove two
When installing drain tube, insert it securely               bolts.
into drain pipe.                                             (4) Remove cover then remove two nuts from
                                                             tilt up assembly.
Length A:                                                    (5) Take off the sunroof panel from body.
    15 mm (0.59 in) or more




                                                                                                B5M0482A
                                       G5M0205
                                                            (6) Installation is in the reverse order of
  (7) Remove eight nuts.                                    removal.
                                                          CAUTION:
                                                          When installing sunroof panel, ensure not to
                                                          pinch its panel end lip.




                                       B5M0312




                                                                                                B5M0483A




                                                     55
5-1   [W16B1]                           SERVICE PROCEDURE
16. Sunroof


2) Sunroof motor assembly:                                    4) Tilt up assembly:
   (1) Remove sunroof panel.                                                      [W16A2].>
   (2) Remove motor cover.                                       (2) Remove tilt up assembly.
   (3) Disconnect connector then remove sunroof
   motor assembly.




                                                                                                    B5M0485A


                                          B5M0484A
                                                                (3) Installation is in the reverse order of
                                                                removal.
   (4) Installation is in the reverse order of
   removal.                                                   B: ADJUSTMENT
3) Sunroof flame:
                                                              1. SEDAN AND WAGON REAR (EXCEPT
   (1) Remove sunroof panel.                                                   OUTBACK)
   (2) Remove roof trim panel.                                                    and roof panel:
   (3) Remove sunroof flame.                                     (1) Remove guide rail cover.
                                                                 (2) Loosen nuts and adjust height by adding
NOTE:
                                                                 (Max: two pieces) and extracting (Max: one
To facilitate installation, leave the two front mount-           piece) shim(s) (Standard: one piece) between
ing bolts on the body.                                           glass lid assembly and lid bracket.
                                                              Difference in height between glass lid assem-
                                                              bly and roof panel:
                                                                   0



◦ Jabse Service Manual Search 2026 ◦ Jabse PravopisonTap.bg ◦ Other service manual resources online : FixyaeServiceinfo