Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual BODY SECTION SUPPLEMENTAL RESTRAINT SYSTEM MSA5TCD98L21264
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD98L21264 documenatation <<
Text preview - extract from the document
SERVICE PROCEDURE [W6B1] 5-5
6. Combination Switch
6. Combination Switch 7) Using steering puller, remove steering wheel.
CAUTION:
A: REMOVAL Do not allow connector to interfere when
1) Turn ignition switch off. removing steering wheel.
2) Disconnect ground cable from battery and wait
for at least 20 seconds before starting work.
3) Remove lower cover.
Disconnect airbag connector (AB3) and (AB8)
below steering column.
CAUTION:
Do not reconnect airbag connector at steering
column until combination switch is securely re-
installed.
G5M0332
8) Remove steering column covers.
9) Removing two retaining screws, remove combi-
nation switch.
G5M0312
4) Disconnect combination switch connectors
from body harness connector.
5) Set front wheels in straight ahead position.
Using TORX BIT T30, remove two TORX bolts.
B5M0106
B: ADJUSTMENT
1. CENTERING ROLL CONNECTOR
Before installing steering wheel, make sure to cen-
ter roll connector built into combination switch.
1) Make sure that front wheels are positioned
straight ahead.
H5M0662A 2) Install steering gearbox, steering shaft and
combination switch properly. Turn roll connector
6) Disconnect airbag connector on back of airbag pin (A) clockwise until it stops.
module. Remove airbag 3) Then, back off roll connector pin (A) approxi-
module, and place it with pad side facing upward. mately 2.65 turns until " " marks aligned.
B5M0457A
H5M0664
15
5-5 [W6C0] SERVICE PROCEDURE
7. Front Sub Sensor
C: INSTALLATION 7. Front Sub Sensor
CAUTION: A: REMOVAL AND INSTALLATION
Failure to do this might damage roll connector.
CAUTION:
1) Before installing combination switch, check to
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo