Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual ENGINE SECTION FUEL SYSTEM MSA5TCD98L20936
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD98L20936 documenatation <<
Text preview - extract from the document
2-8 [W2A1] SERVICE PROCEDURE
2. Fuel Tank
4) Start the engine. 2. Fuel Tank
5) Measure fuel pressure while disconnecting
pressure regulator vacuum hose from collector A: REMOVAL
chamber.
1. 2200 cc FWD AND TAIWAN SPEC.
Fuel pressure: VEHICLES
235 -- 265 kPa (2.4 -- 2.7 kg/cm2, 34 --
38 psi) 1) Release fuel pressure.
2) Open fuel flap lid, and remove fuel filler cap.
G2M0348
B2M1746
6) After connecting pressure regulator vacuum
hose, measure fuel pressure. 3) Disconnect battery ground cable.
Fuel pressure:
177 -- 206 kPa (1.8 -- 2.1 kg/cm2, 26 --
30 psi)
B2M1723
4) Drain fuel from fuel tank.
G2M0348
G2M0345
16
SERVICE PROCEDURE [W2A1] 2-8
2. Fuel Tank
5) Remove rear seat cushion. (Sedan model) 10) Remove rear exhaust pipe.
(1) Separate rear exhaust pipe from center
exhaust pipe.
(2) Separate rear exhaust pipe from muffler.
(3) Remove bracket from rubber cushion, and
remove exhaust pipe.
NOTE:
To facilitate the removal of parts, apply a coat of
SUBARU CRC5-56 (Part No. 004301003).
B2M1736
6) Move rear seat cushion forward. (Wagon
model)
S2M0158
11) Remove heat sealed cover.
B2M1737
7) Disconnect connector of fuel tank cord from
rear harness.
S2M0166
12) Remove muffler assembly.
NOTE:
To facilitate the removal of parts, apply a coat of
B2M1738 SUBARU CRC5-56 (Part No. 004301003).
8) Push grommet which holds fuel tank cord on
floor panel into under the body.
B2M0063
B2M1739A
9) Lift-up the vehicle.
17
2-8 [W2A1] SERVICE PROCEDURE
2. Fuel Tank
13) Remove bolts which hold parking brake cable 16) Loosen clamp, and disconnect fuel filler hose
holding bracket. (A) and air vent hose (B) from fuel filler pipe and
air vent pipe.
S2M0191
B2M1193B
14) Remove rear differential assembly. (AWD
model) 17) Loosen clamp, and then disconnect fuel deliv-
(1) Remove rear axle shafts from rear differen- ery hose (A).
tial assembly. 18) Move clips, and disconnect fuel return hose
(2) Remove rear differential front cover. (B) and evaporation hose (C).
(3) Remove propeller shaft.
(4) Remove lower differential bracket.
(5) Set transmission jack under rear differential.
(6) Remove bolts which install rear differential
onto rear crossmember.
B2M0310B
19) While holding fuel tank, remove bolts from
bands and dismount fuel tank.
WARNING:
A helper is required to perform this work.
G3M0059
15) Remove rear crossmember.
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo