Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual ELECTRICAL SECTION BODY ELECTRICAL SYSTEM MSA5TCD98L21298

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download MSA5TCD98L21298 documenatation <<

Text preview - extract from the document

SERVICE PROCEDURE [W17B1] 6-2
17. Power Window

3. HORN 17. Power Window
Make sure that horn sounds when battery voltage A: REMOVAL AND INSTALLATION
is applied between connector terminal and horn
body. 1. MAIN SWITCH, SUB SWITCH AND
POWER WINDOW MOTOR
Remove and install power window main switch,
sub switch and motor.
NOTE:
To remove the power window motor, it is necessary
to disassemble the door component parts.
B: INSPECTION
1. MAIN SWITCH
B6M0127 Set power window main switch to each position
and check continuity between terminals.

4. CIGARETTE LIGHTER
1) Remove plug. Then, check element's contact
for wear, and element for accumulation of ashes,
foreign particles, etc.
2) Check element for discontinuity.
3) Remove socket and clean element. Then,
check for wear or foreign particles on element's
contact and mating surface.
4) Ensure that cigarette lighter returns within 20
seconds after it is turned to ON.

B6M0128A

31
6-2 [W17B2] SERVICE PROCEDURE
17. Power Window

B6M0711

2. SUB SWITCH
Set power window sub switch to each position and
check continuity between terminals.

B6M0130A

32
SERVICE PROCEDURE [W18A2] 6-2
18. Power Door Lock

B6M0712A

3. POWER WINDOW MOTOR 18. Power Door Lock
1) Make sure that power window motor rotates
properly when battery voltage is applied to termi- A: REMOVAL AND INSTALLATION
nals of motor connector. 1. FRONT AND REAR DOOR, AND REAR
2) Change polarity of battery connections to termi- GATE LOCK ACTUATOR
nals to ensure that motor rotates in reverse direc-
tion. Remove and install front door lock actuator, rear
door lock actuators, and rear gate lock actuator.
4. POWER WINDOW RELAY
Check continuity between terminals as indicated in NOTE:
table, when connecting the battery to terminal No. To remove and install the actuators, it is necessary
1 and No. 3. to disassemble the door component parts.
When current flows. Between termi- Continuity 2. DOOR LOCK TIMER
nals No. 2 and exists.
No. 4
1) Disconnect battery ground cable.
When current does not Between termi- Continuity does
flow. nals No. 2 and not exist.
No. 4
Between termi- Continuity
nals No. 1 and exists.
No. 3

G6M0095

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo