Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual ELECTRICAL SECTION BODY ELECTRICAL SYSTEM MSA5TCD98L21304
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD98L21304 documenatation <<
Text preview - extract from the document
6-2 [W22C2] SERVICE PROCEDURE
23. Security System
4) Turn ignition switch OFF with main switch ON 23. Security System
(which is indicated by illumination.).
5) Turn ignition switch ON again to ensure that A: REMOVAL AND INSTALLATION
indicator light remains OFF.
1. STARTER INTERRUPT RELAY
2. COMMAND SWITCH NOTE:
1) Check that command switch is properly set in The starter interrupt relay and headlight alarm
"SET/COAST", "RESUME/ACCEL" or "CANCEL" relay use the same parts and are mounted parallel
mode. to each other. Therefore, before removal and
2) Also check that command switch returns to the installation, identify the starter interrupt relay by the
original position when released. color of its wiring connection.
3. CONSTANT SPEED TEST
1) Remove instrument panel lower cover.
1) Turn main switch ON.
2) Drive vehicle at speed greater than 40 km/h (25 2) Disconnect connector of starter interrupt relay.
MPH). 3) Remove starter interrupt relay.
3) Press command switch to set in "SET/COAST"
mode.
4) Ensure that vehicle is maintained at the speed
set when command switch was pressed.
4. ACCELERATION TEST
1) Set vehicle speed at speed greater than 40
km/h (25 MPH).
2) Ensure that vehicle continues to accelerate
while holding command switch in RESUME/
ACCEL mode, and that vehicle maintains that B6M0361A
optional speed when command switch is released.
4) Installation is in the reverse order of removal.
5. DECELERATION TEST
2. HEADLIGHT ALARM RELAY
1) Set vehicle speed at optional speed greater
than 40 km/h (25 MPH). NOTE:
2) Ensure that vehicle continues to decelerate The headlight alarm relay and starter interrupt
while holding command switch in SET/COAST relay use the same parts and are mounted parallel
mode, and that it maintains that optional speed to each other. Therefore, before removal and
when command switch is released. installation, identify the headlight alarm relay by
the color of its wiring connection.
of 30 km/h (19 MPH) during deceleration, cruise 1) Remove instrument panel lower cover.
control will be released. 2) Disconnect connector of headlight alarm relay.
3) Remove headlight alarm relay.
B6M0361A
4) Installation is in the reverse order of removal.
44
SERVICE PROCEDURE [W23A5] 6-2
23. Security System
3. ENGINE HOOD SWITCH 3) Remove trunk lid key cylinder switch by push-
ing it.
1) Disconnect connector of engine hood switch
4) Installation is in the reverse order of removal.
from bottom side of switch body.
2) Remove headlight (LH). ◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo