Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual MECHANICAL COMPONENTS SECTION HEATER AND VENTILATOR MSA5TCD98L21152

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download MSA5TCD98L21152 documenatation <<

Text preview - extract from the document

4-6 [W3A0] SERVICE PROCEDURE
3. Blower Motor Assembly

3. Blower Motor Assembly 4. Control Unit
A: REMOVAL AND INSTALLATION A: REMOVAL AND INSTALLATION
1) Disconnect GND cable from battery. 1) Disconnect GND cable from battery.
2) Remove glove box and pocket back panel. 2) Set temperature control lever to "FULL COLD"
position.
3) Disconnect blower motor harness connector. 3) Remove temperature control cable from heater
unit.
NOTE:
Do not attempt to move link of heater unit during
installation.

B5M0025

4) Disconnect aspirator pipe (A).
5) Remove blower motor mounting screw.

B5M0027

4) Remove cup holder.
5) Remove center panel and then disconnect con-
nector.

B4M1082B

6) Remove blower motor assembly.
7) Installation is in the reverse order of removal.

B4M0370

6) Remove control unit assembly and disconnect
connector.

B4M0059

7) Installation is in the reverse order of removal.
NOTE:
Before control unit installation, set temperature
control lever to "FULL COLD" position.

8
SERVICE PROCEDURE [W4B2] 4-6
4. Control Unit

B: INSPECTION
1. FAN SWITCH
Check continuity between terminals at each switch position.

B4M1089A

2. CONTROL UNIT
Check circuit continuity between each terminal, when push control switch is turned ON.

B4M1090A

9
4-6 [W4C0] SERVICE PROCEDURE
5. Intake Door Motor

C: ADJUSTMENT 5. Intake Door Motor
1) Operate temperature control lever to "FULL A: REMOVAL AND INSTALLATION
COLD" position.
2) Install control cable to lever (A). While pushing 1) Disconnect GND cable from battery.
2) Remove glove box and pocket back panel.
outer cable, secure control cable with clip (B).

B4M0062C
B5M0025

3) Remove heater duct or evaporator. (With A/C
model).
4) Remove intake unit from the vehicle.

G4M0561

5) Remove screws which secure intake door
motor to intake unit.
NOTE:
Ensure that RECIRC switch is set to "ON".

G4M0562

6) Installation is in the reverse order of removal.

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo