Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual MECHANICAL COMPONENTS SECTION STEERING SYSTEM MSA5TCD98L21102
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD98L21102 documenatation <<
Text preview - extract from the document
SERVICE PROCEDURE [W6A2] 4-3
6. Control Valve (Power Steering Gearbox) [RHD model]
6. Control Valve (Power Steering Gearbox) [RHD model]
A: CHECKING OIL LEAKING POINTS
B4M0668A
1. OIL LEAKING POINTS 2. OIL LEAK CHECK PROCEDURE AND
1) If leak point is other than a, b, c, or d, perform REPLACEMENT PARTS
check step 5) in "OIL LEAK CHECK PROCEDURE NOTE:
AND REPLACEMENT PARTS" before dismounting Parts requiring replacement are described in the
gearbox from vehicle. If smallest unit of spare parts including damaged
gearbox is dismounted without confirming where parts and spare parts damaged. In actual disas-
the leak is, it must be mounted again to locate the sembly work, accidental damage as well as inevi-
leak point. table damage to some related parts must be taken
2) Even if the location of the leak can be easily into account, and spare parts for them must also
found by observing the leaking condition, it is nec- be prepared. However, it is essential to pinpoint the
essary to thoroughly remove the oil from the sus- cause of trouble, and limit the number of replace-
pected portion and turn the steering wheel from ment parts as much as possible.
lock to lock about 30 to 40 times with engine 1) Leakage from "a"
running, then make comparison of the suspected The oil seal is damaged. Replace valve assembly
portion between immediately after and several with a new one.
hours after this operation. 2) Leakage from "b"
3) Before starting oil leak repair work, be sure to The torsion bar O-ring is damaged. Replace valve
clean the gearbox, hoses, pipes, and surrounding assembly with a new one.
parts. After completing repair work, clean these 3) Leakage from "c"
areas again. The oil seal is damaged. Replace valve assembly
with a new one.
4) Leakage from "d"
The pipe is damaged. Replace the faulty pipe or
O-ring.
5) If leak is other than a, b, c, or d, and if oil is
leaking from the gearbox, move the right and left
43
4-3 [W6B0] SERVICE PROCEDURE
6. Control Valve (Power Steering Gearbox) [RHD model]
boots toward tie-rod end side, respectively, with the 2) Remove the two bolts securing valve housing.
gearbox mounted to the vehicle, and remove oil
from the surrounding portions. Then, turn the steer-
ing wheel from lock to lock 30 to 40 times with the
engine running, then make comparison of the
leaked portion immediately after and several hours
after this operation.
6) Leakage from "e"
There are two possible causes. Take following step
first. Remove the pipe assembly B from the valve
housing, and close the circuit with ST.
ST 926420000 PLUG G4M0818
Turn the steering wheel from lock to lock 30 to 40
times with the engine running, then make compari- 3) Remove valve housing, pinion and valve as a
son of the leaked portion between immediately unit.
after and several hours after this operation.
CAUTION:
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo