Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1998 1998 Service Manual MECHANICAL COMPONENTS SECTION WHEELS AND AXLES MSA5TCD98L21083

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document

>> Download MSA5TCD98L21083 documenatation <<

Text preview - extract from the document

4-2 [W5A0] SERVICE PROCEDURE
5. Replacement of Front SFJ, DOJ and BJ Boots

5. Replacement of Front SFJ, 6. Replacement of Rear DOJ
DOJ and BJ Boots and BJ Boots
A: REMOVAL A: REMOVAL
1) Disconnect ground cable from battery. 1) Disconnect ground cable from battery.
2) Jack-up vehicle, support it with safety stands 2) Lift-up vehicle, and remove rear wheel cap and
(rigid racks), and remove front wheel cap and wheels.
wheels. NOTE:
NOTE: Axle nut need not be removed.
Do not remove axle nut. 3) Remove ABS sensor clamps and parking brake
3) Remove stabilizer link. cable bracket.
4) Disconnect transverse link from housing. 4) Disconnect stabilizer link from lateral link.
5) Remove spring pin which secures transmission 5) Remove bolts which secure lateral link assem-
spindle to DOJ/SFJ. bly to rear housing.
CAUTION: 6) Remove bolts which secure trailing link assem-
Use a new spring pin. bly to rear housing.
7) Remove crossmember reinforcement lower
from crossmember (4 door model only).
8) Remove DOJ from rear differential using ST.
(Except 2200 cc AT vehicles)
ST 28099PA100 DRIVE SHAFT REMOVER
CAUTION:
Do not remove circlip attached to inside of dif-
ferential.

G4M0279

6) Remove SFJ, DOJ and BJ boots from drive
shaft. or

B: INSTALLATION
1) Install SFJ, DOJ and BJ boots to drive shaft.
or G4M0994
2) Install DOJ/SFJ on transmission spindle and
drive spring pin into place. CAUTION:
Be careful not to damage side bearing retainer.
CAUTION:
Always use bolt as shown in figure, as support-
Always use a new spring pin.
ing point for ST during removal.
ST 28099PA100 DRIVE SHAFT REMOVER

G4M0279

3) Connect transverse link to housing. G4M0995
4) Install stabilizer link.

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo