Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1999 1999 Service Manual BODY SECTION BODY AND EXTERIOR MSA5TCD99L383
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD99L383 documenatation <<
Text preview - extract from the document
5-1 [W16A1] SERVICE PROCEDURE
16. Sunroof
16. Sunroof 3) Sunroof frame:
(1) Remove sunroof switch, center and rear
A: REMOVAL AND INSTALLATION room lamps.
(2) Remove roof trim, rear quarter trim, pillar
1. SEDAN AND WAGON REAR (EXCEPT
trim, etc.
OUTBACK) (3) Remove glass lid assembly.
1) Glass lid assembly: (4) Remove two harness support clips.
(1) Completely open sun shade. (Push it back
far.)
(2) Remove a clip and detach guide rail cover.
(3) Remove six nuts from the left and right lid
bracket.
(4) Working inside, slightly raise glass lid
assembly until it is disengaged from lid bracket.
B5M0310A
(5) Disconnect harness clips and connector of
sunroof motor.
(6) Disconnect front and rear drain tubes.
CAUTION:
When installing drain tube, insert it securely
B5M0307A into drain pipe.
(5) Hold both ends of glass lid assembly and Length A:
remove it at an angle. 15 mm (0.59 in) or more
(6) Installation is in the reverse order of
removal.
2) Sunroof motor and relay:
(1) Remove center pillar trim upper.
(2) Remove front pillar trim upper.
(3) Remove assist grip on left side.
(4) Remove sunvisor with hook.
(5) Remove sunroof switch.
(6) Remove rearview mirror. G5M0205
(7) While rolling up roof trim, disconnect har-
ness clips and connector. (7) Remove eight nuts.
(8) While rolling up roof trim, remove spot lamp
bracket and sunroof motor.
(9) Installation is in the reverse order of
removal.
B5M0312
B5M0308B
58
SERVICE PROCEDURE [W16A2] 5-1
16. Sunroof
(8) Remove set bracket mounting bolts. 2) Sunroof motor assembly:
(9) Remove sunroof frame. (1) Remove sunroof panel.
(2) Remove motor cover.
(3) Disconnect connector then remove sunroof
motor assembly.
B5M0382A
(10) Installation is in the reverse order of
removal.
B5M0484A
2. WAGON FRONT (OUTBACK)
1) Sunroof panel: (4) Installation is in the reverse order of
(1) Tilt up the front sunroof (Most upper posi- removal.
tion). 3) Sunroof flame:
(2) Disconnect ground cable from battery. (1) Remove sunroof panel.
bolts. (2) Remove roof trim panel.
tilt up assembly. (3) Remove sunroof flame.
(5) Take off the sunroof panel from body. NOTE:
To facilitate installation, leave the two front mount-
ing bolts on the body.
B5M0482A
(6) Installation is in the reverse order of
B5M0311A
removal.
CAUTION: (4) Installation is in the reverse order of
When installing sunroof panel, ensure not to removal.
pinch its panel end lip.
B5M0483A
59
5-1 [W16B1] SERVICE PROCEDURE
16. Sunroof
4) Tilt up assembly: 2) Alignment of glass lid assembly with roof panel:
(1) Remove sunroof flame. (2) Loosen nuts and move glass lid assembly
(2) Remove tilt up assembly. to either side to adjust front, rear, right, and left
side partitions.
Partition clearance:
7.0 ◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo