Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 1995-1999 Approved Subaru Legacy 1999 1999 Service Manual TRANSMISSION AND DIFFERENTIAL SECTION MANUAL TRANSMISSION AND DIFFERENTIAL MSA5TCD99L165

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document
MSA5TCD99L165


>> Download MSA5TCD99L165 documenatation <<

Text preview - extract from the document
                                         SERVICE PROCEDURE                                              [W4A1] 3-1
                                                                                               4. Main Shaft Assembly


5) If specified starting torque range cannot be               4. Main Shaft Assembly
obtained when a No. 1 adjusting washer is used,
then select a suitable No. 2 adjusting washer from            A: DISASSEMBLY
those listed in the following table. Repeat steps 1)
through 4) to adjust starting torque.                         1. 2200 cc MODEL
                                                              1) Put vinyl tape around main shaft splines to pro-
                                                              tect oil seal from damage. Then pull out oil seal
                                                              and needle bearing by hand.
                                                              2) Remove lock nut from transmission main shaft
                                                              assembly.
                                                              NOTE:
                                                              Remove caulking before taking off lock nut.
                                                              ST1      498937000     TRANSMISSION HOLDER
                                                              ST2      499987003     SOCKET WRENCH (35)
                                            B3M0536I

   (A)   Adjusting washer No. 1
   (B)   Adjusting washer No. 2

 Starting torque   Dimension H       Washer No. 2
       Low            Small        Select thicker one.
       High           Large        Select thinner one.

                 Adjusting washer No. 2
          Part No.               Thickness mm (in)
         803025059                 3.850 (0.1516)                                                         B3M0087A

         803025054                 4.000 (0.1575)
                                                              3) Remove insert stopper plate, sleeve and hub
         803025058                 4.150 (0.1634)
                                                              assembly No. 2, baulk ring, 5th drive gear, and
6) Recheck that starting torque is within specified           needle bearing.
range, then clinch lock nut at four positions.




                                                                                                          B3M1364A

                                                                 (A)    Insert stopper plate
                                                                 (B)    Sleeve and hub assembly No. 2
                                                                 (C)    Baulk ring
                                                                 (D)    5th drive gear
                                                                 (E)    Needle bearing (32



◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo