Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Subaru Legacy 2000-2003 Approved Subaru Legacy 2000 2000 Service Manual BODY SECTION Body and Exterior MSA5TCD00L15962
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download MSA5TCD00L15962 documenatation <<
Text preview - extract from the document
SERVICE PROCEDURE [W15A2] 5-1
15. Sunroof
15. Sunroof 4) Disconnect connector of sunroof motor.
5) Disconnect front and rear drain tubes.
A: REMOVAL AND INSTALLATION CAUTION:
1. GLASS LID (SEDAN BODY) When installing drain tube, insert it securely
into drain pipe.
1) Completely open sun shade. (Push it back far.)
2) Remove a clip (a) and detach guide rail cover Length A:
(b). 15 mm (0.59 in) or more
3) Remove four nuts from the left and right lid
bracket (c).
4) Working inside, slightly raise glass lid (d) until it
is disengaged from lid bracket.
5) Hold both ends of glass lid (d) and remove it at
an angle.
G5M0205
6) Remove motor cover.
B5M0898A
6) Installation is in the reverse order of removal.
2. SUNROOF FRAME (SEDAN BODY)
1) Remove sunroof garnish (a).
B5M0900
7) Remove front sunroof bracket (a) and rear sun-
roof bracket (b).
B5M0899A
2) Remove roof trim.
3) Remove harness support clips from sunroof
frame.
B5M0901A
B5M0310A
45
5-1 [W15A3] SERVICE PROCEDURE
15. Sunroof
8) Detach sunroof frame while removing mounting 6) Installation is in the reverse order of removal.
nut. CAUTION:
When installing sunroof panel, ensure not to
pinch its panel end lip.
B5M0902
9) Pull out sun shade from sunroof frame.
B5M0483A
4. FRONT SUNROOF FRAME (WAGON
BODY)
1) Remove roof trim.
2) Remove front glass lid.
3) Disconnect drain tubes (A) from front sunroof
frame.
4) Disconnect sunroof harness.
B5M0903
5) Remove bolts (B), nuts (C) and clips (D) then
detach sunroof frame.
10) Installation is in the reverse order of removal.
CAUTION:
Be careful not to snag the harness.
NOTE:
Make sure to connect harness connector.
3. FRONT GLASS LID (WAGON BODY)
1) Tilt up the front sunroof (Most upper position).
2) Disconnect ground cable from battery.
3) Remove sunroof switch then remove two bolts. B5M0741A
4) Remove cover (A) then remove two nuts from
tilt up assembly. 6) Installation is in the reverse order of removal.
5) Take off the sunroof panel from body.
B5M0482B
46
SERVICE PROCEDURE [W15A6] 5-1
15. Sunroof
CAUTION: 6. REAR SUNROOF FRAME (WAGON
Be careful not to snag the harness. BODY)
NOTE: 1) Remove roof trim.
When installing drain tube, insert it securely into 2) Remove rear glass lid.
drain pipe. 3) Disconnect drain tubes (C) from rear sunroof
Length A: frame.
15 mm (0.59 in) or more 4) Disconnect sunroof harness connector.
5) Remove installation bolts (D) and nuts (E) and
then detach sunroof frame.
G5M0205
5. REAR GLASS LID (WAGON BODY)
1) Completely close glass lid and open sunshade.
2) Detach covers (A) and then remove nuts (B).
B5M0742A
6) Installation is in the reverse order of removal.
CAUTION:
Be careful not to snag the harness.
NOTE:
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo