Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota 4Runner 1996-2003 Approved SIL techinfo.toyota.com ileaf 02toyrm 02toypdf 02rmsour 2002 024runne rs srsair prec

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.




Image preview - the first page of the document
prec


>> Download prec documenatation <<

Text preview - extract from the document
                                                                                                RS-1
                   SUPPLEMENTAL RESTRAINT SYSTEM   -   SRS AIRBAG


SRS AIRBAG
                                                                                                RS0B6-03


PRECAUTION
NOTICE:
 S  The 4 RUNNER is equipped with an SRS, which comprises a driver airbag and front passenger
    airbag. Failure to carry out service operations in the correct sequence could cause the SRS to
    unexpectedly deploy during servicing, possibly leading to a serious accident. Further, if a mis-
    take is made in servicing the SRS, it is possible the SRS may fail to operate when required. Be-
    fore performing servicing (including removal or installation of parts, inspection or replace-
    ment), be sure to read the following items carefully, then follow the correct procedure described
    in the repair manual.
 S  Malfunction symptoms of the SRS are difficult to confirm, so the DTCs become the most impor-
    tant source of information when troubleshooting the SRS, always inspect the DTCs before dis-
    connecting the battery.
 S  Even in cases of a minor collision where the SRS does not deploy, the steering wheel pad, front
    passenger airbag assembly, airbag sensor assembly and front airbag sensor should be in-
    spected. (See page RS-12 , RS-26 , RS-39 and RS-44 )
 S  Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
 S  Never disassemble and repair the steering wheel pad, front passenger airbag assembly, airbag
    sensor assembly or front airbag sensor in order to reuse it.
 S  If the steering wheel pad, front passenger airbag assembly, airbag sensor assembly or front
    airbag sensor has been dropped, or if there are cracks, dents or other defects in the case, brack-
    et or connector, replace it with new one.
 S  Use a volt/ohmmeter with high impedance (10 k/V minimum) for troubleshooting the system's
    electrical circuits.
 S  Information labels are attached to the periphery of the SRS components. Follow the instruction
    on the notices.
 S  After work on the SRS is completed, check the SRS warning light. (See page DI-377 )
 S  If the vehicle is equipped with a mobile communication system, refer to the precaution in the
    IN section.
CAUTION:
 S  Work must be started 90 seconds after the ignition switch is turned to the "LOCK" position and
    the negative (-) terminal cable is disconnected from the battery. (The SRS is equipped with a
    back-up power source so that if work is started within 90 seconds of disconnecting the nega-
    tive (-) terminal cable of the battery, the SRS may be deployed.)
 S  When the negative (-) terminal cable is disconnected from the battery, the memory of the clock
    and audio system will be canceled. So before starting work, make a record of the contents mem-
    orized in the audio memory system. When work is finished, reset the audio systems as before
    and adjust the clock. To avoid erasing the memory of each memory system, never use a back-
    up power supply from outside the vehicle.
 S  Before repairs, remove the airbag sensor if shocks are likely to be applied to the sensor during
    repairs.
 S  Do not expose the steering wheel pad, front passenger airbag assembly, airbag sensor assem-
    bly or front airbag sensor directly to hot air or flames.




2002 4RUNNER (RM887U)

                                                             Author :         Date :            1420



◦ Jabse Service Manual Search 2026 ◦ Jabse PravopisonTap.bg ◦ Other service manual resources online : FixyaeServiceinfo