Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Camry 1994.2002-2007 Approved Toyota Camry 2007 Hybrid 49 07camhvo 0703
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download 0703 documenatation <<
Text preview - extract from the document
'07Camry hybrid_U (L/O 0610)
SECTION 7- 3
DO-IT-YOURSELF MAINTENANCE
Electrical components
Checking 12 volt battery condition . . . . . . . . . . . . . . . . . . . . . . . . . . . . 369
12 volt battery recharging precautions . . . . . . . . . . . . . . . . . . . . . . . . 370
Checking and replacing fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 371
Checking the fusible link . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 372
Adding washer fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 373
Replacing light bulbs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 373
368
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
Checking 12 volt battery
condition--
--12 volt battery location --Precautions
CAUTION EMERGENCY MEASURES
D If electrolyte gets in your eyes,
BATTERY PRECAUTIONS flush your eyes with clean water
The battery produces flammable and immediately and get immediate
explosive hydrogen gas. medical attention. If possible, con-
D Do not cause a spark from the bat- tinue to apply water with a sponge
tery with tools. or cloth while en route to the medi-
cal office.
D Do not smoke or light a match near
the battery. D If electrolyte gets on your skin,
thoroughly wash the contact area. If
D When replacing the battery, only you feel pain or burning, get medi-
install a battery designated for your cal attention immediately.
hybrid vehicle. Using a conventional
A 12 volt battery is located in the battery may cause hydrogen gas to D If electrolyte gets on your clothes,
right-hand side of the trunk. Remove build up in the vehicle. there is a possibility of its soaking
the cover to access the battery. through to your skin, so immediate-
The electrolyte contains poisonous ly take off the exposed clothing and
The battery with a flammable hydrogen and corrosive sulfuric acid. follow the procedure above, if nec-
gas exhaust valve is specially desig-
nated for your vehicle. When replacing
D Avoid contact with eyes, skin or essary.
the battery, contact your Toyota dealer.
clothes. D If you accidentally swallow electro-
D Never ingest electrolyte. lyte, drink a large quantity of water
D Wear protective safety glasses when or milk. Follow with milk of magne-
working near the battery. sia, beaten raw egg or vegetable
oil. Then go immediately for emer-
D Keep children away from the bat- gency help.
tery.
369
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
--Checking the 12 volt battery 12 volt battery recharging
exterior precautions
During recharging, the battery is pro-
NOTICE
ducing hydrogen gas.
Terminals
z Be sure the hybrid system and all Therefore, before recharging:
accessories are off before perform-
1. If recharging with the battery installed
ing maintenance.
on the vehicle, be sure to disconnect
z When checking the battery, remove the ground cable.
the ground cable from the negative
2. Be sure the power switch on the re-
terminal ("-" mark) first and rein-
charger is off when connecting the
stall it last.
charger cables to the battery and when
Hold-down Ground cable z Be careful not to cause a short cir- disconnecting them.
clamp cuit with tools.
z Take care no solution gets into the CAUTION
battery when washing it.
Check the battery for corroded or loose D Always charge the battery in an un-
terminal connections, cracks, or loose confined area. Do not charge the
hold-down clamp. battery in a garage or closed room
a. If the battery is corroded, wash it off where there is not sufficient ventila-
with a solution of warm water and bak- tion.
ing soda. Coat the outside of the termi- D Only do a slow charge (5 A or
nals with grease to prevent further cor- less). Charging at a quicker rate is
rosion. dangerous. The battery may ex-
b. If the terminal connections are loose, plode, causing personal injuries.
tighten their clamp nuts--but do not
overtighten.
NOTICE
c. Tighten the hold-down clamp only
enough to keep the battery firmly in Never recharge the battery while the
place. Overtightening may damage the hybrid system is operating. Also, be
battery case. sure all accessories are turned off.
370
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
Checking and replacing fuses
Good Blown
Good Blown
Type A Type C
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See "Fuse locations" on page 348 in Sec-
tion 7-1 for locations of the fuses.
Turn the hybrid system and inoperative
component off. Pull the suspected fuse
Good Blown straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
page 386 in Section 8 for the functions
controlled by each circuit.
Type B Type B fuses--When any of the fuses are
blown, contact your Toyota dealer.
371
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
Checking the fusible link
Type A fuses can be pulled out by the If the new fuse immediately blows out,
pull-out tool. The location of the pull-out there is a problem with the electrical sys-
tool is shown in the illustration. tem. Have your Toyota dealer correct it as
If you are not sure whether the fuse has soon as possible.
blown, try replacing the suspected fuse
with one that you know is good. CAUTION
If the fuse has blown, push a new fuse Never use a fuse with a higher am-
into the clip.
perage rating, or any other object, in
Only install a fuse with the amperage rat- place of a fuse. This may cause ex-
ing designated on the fuse box lid. tensive damage and possibly a fire.
If you do not have a spare fuse, in an
emergency you can pull out the "RADIO
NO.1" or "PWR OUTLET" fuse, which may
be dispensable for normal driving, and use If the headlights or other electrical
it if its amperage rating is the same. components do not work and the fuses
are O.K., check the fusible link fitted
If you cannot use one of the same amper- on the "+" terminal of the 12 volt bat-
age, use one that is lower, but as close tery. If the link is melted, it must be
to the rating as possible. If the amperage
replaced.
is lower than that specified, the fuse
might blow out again but this does not If there is an overload in the circuits, the
indicate anything wrong. Be sure to get fusible links are designed to melt before
the correct fuse as soon as possible and the entire wiring harness is damaged.
return the substitute to its original clip. The battery is located in the right-hand
It is a good idea to purchase a set of side of the trunk. See "--12 volt battery
spare fuses and keep them in your ve- location" on page 369 in this Section.
hicle for emergencies.
372
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
Adding washer fluid Replacing light bulbs--
If the washer does not work or the The following illustrations show how to
NOTICE
message "LOW WASHER FLUID" ap- gain access to the bulbs. When replacing
pears on the multi-information display, a bulb, make sure the hybrid system and Only use a bulb of the listed type.
the washer tank may be empty. Add light switch are off. Use bulbs with the
washer fluid. wattage ratings given in the table.
The inside of the lens of exterior lights
You may use plain water as washer fluid. The stop/tail lights and high mounted stop- such as headlights may temporarily fog up
However, in cold areas where tempera- light consist of a number of LEDs. If any when the lens becomes wet in the rain or
tures range below the freezing point, use of the LEDs burn out, take your vehicle in a car wash. This is not a problem
washer fluid containing antifreeze. This to your Toyota dealer to have the light because the fogging is caused by the
product is available at your Toyota dealer replaced. temperature difference between the outside
and most auto parts stores. Follow the If two or more LEDs in a stop light burn and inside of the lens, just like the
manufacturer's directions for how much to out, your vehicle may not conform to local windshield fogs up in the rain. However, if
mix with water. laws (SAE). there is a large drop of water on the
inside of the lens, or if there is water
NOTICE pooled inside the light, contact your
CAUTION
Do not use engine antifreeze or any Toyota dealer.
other substitute because it may dam- D To prevent burning yourself, do not
age your vehicle's paint. replace the light bulbs while they
are hot.
D Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
373
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
--Front turn signal/parking,
side marker, tail and back-up
lights, and high mounted
stoplight
Bulb A: HB3 halogen bulbs If the front turn signal/parking, side
Light bulbs W Type B: H11 halogen bulbs marker, tail or back-up lights, or high
No.
C: Wedge base bulbs (clear) mounted stoplight burns out, contact
Headlights D: Wedge base bulbs (amber) your Toyota dealer.
9005 60 A
(high) E: Double end bulbs
Headlights (low) -- 55 B NOTICE
Front side Do not try to replace the front turn
-- 5 C
marker lights signal/parking, side marker, tail, back-
up light and high mounted stoplight
Front turn
bulbs by yourself. You may damage
signal/parking 3457NAK 30/8 D
the vehicle.
lights
Rear turn signal
-- 21 D
lights
License plate
-- 5 C
lights
Back-up lights 921 16 C
Personal lights -- 5 C
Interior light -- 8 E
Door courtesy
168 5 C
lights
Vanity lights -- 8 C
Glove box light -- 1.2 C
Trunk light -- 3.8 C
374
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
--Headlights
Low beam (outside)
High beam
(inside)
1. Open the hood. Turn the bulb base 2. Unplug the connector while depress- 3. Plug in a new bulb into the connec-
counterclockwise to the front of the ing the lock release. tor and install it into the mounting
vehicle as shown. If the connector is tight, wiggle it. hole.
The above illustration shows the left-hand Aiming is not necessary after replacing
headlight. the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
375
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
--Rear turn signal lights
376
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
'07Camry hybrid_U (L/O 0610)
377
2007 CAMRY HV from Aug. '06 Prod. (OM33727U)
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo