Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Camry 1994.2002-2007 Approved Toyota Camry 2007 Hybrid 50 bodydime generali
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download generali documenatation <<
Text preview - extract from the document
BODY DIMENSIONS DI-1
Three-dimensional Center-to-center GENERAL INFORMATION
distance straight-line
1. BASIC DIMENSIONS
distance
(a) There are two types of dimensions in the diagram.
(1) (Three-dimensional distance)
S Straight-line distance between the centers of two
measuring points.
Two-dimensional Center-to-center horizontal (2) (Two-dimensional distance)
distance distance in forward /
rearward direction
S Horizontal distance in forward/rearward between the
centers of two measuring points.
S The height from an imaginary standard line.
(b) In cases in which only one dimension is given, left and right
are symmetrical.
Vertical distance Vertical distance (c) The dimensions in the following drawing indicate actual dis-
to center to lower surface tance. Therefore, please use the dimensions as a refer-
ence.
Imaginary Standard Line
(d) The line that connects the places listed below is the imagi-
nary standard line when measuring the height. (The dimen-
sions are printed in the text.)
Under Surface of SYMBOL Name
The Rocker Panel The place that was lowered A mm from the under surface of
1
the rocker panel centered on the front jack up point.
A mm B mm C mm The place that was lowered B mm from the under surface of
2
the rocker panel centered between 1 and 3.
Imaginary Standard Line The place that was lowered C mm from the under surface of
3
the rocker panel centered on the rear jack up point.
DI-2 BODY DIMENSIONS
Plate Looseness 2. MEASURING
(a) Basically, all measurements are to be done with a tracking
Body Looseness
gauge. For portions where it is not possible to use a track-
ing gauge, a tape measure should be used.
(b) Use only a tracking gauge that has no looseness in the
body, measuring plate, or pointers.
Pointer Looseness
Pointer
Master Gauge
HINT:
Wrong Correct 1) The height of the left and right pointers must be equal.
2) Always calibrate the tracking gauge before measuring
or after adjusting the pointer height.
3) Take care not to drop the tracking gauge or otherwise
shock it.
Pointer 4) Confirm that the pointers are securely in the holes.
(c) When using a tape measure, avoid twists and bends in the
tape.
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo