Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1989 brake system

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download brake system documenatation <<

Text preview - extract from the document

                                                                    BRAKE SYSTEM

                                                                     1988 Toyota Celica




                1988-89 BRAKES
                Toyota

                Celica, Corolla, MR2, Tercel

       DESCRIPTION
         The hydraulic brake system uses a tandem master cylinder with
a vacuum power assist servo. MR2 and some Celica models are equipped
with 4-wheel disc brakes. Corolla and Corolla FX are available with
either rear drum or rear disc brakes. Tercel models are equipped with
front disc and rear drum brakes.
         A load sensing proportioning valve is used on some models to
regulate brake pressure between the front and rear circuits. The rear
brakes on all models are self-adjusting.
         The parking brake lever mechanically activates the rear
brakes. On models with rear drum brakes, a cable applies the rear
shoes. On MR2, Corolla and Corolla FX models with rear disc brakes,
the parking brake applies the rear pads. On Celica models, the parking
brake is a duo servo mechanical drum brake design built into the bell
of rear rotor assemblies.

       DRUM BRAKES ADJUSTMENTS
NOTE:           All rear drum brakes have a self-adjuster which is activated
                when brake pedal is applied as vehicle travels in reverse.

         To manually adjust rear brakes, raise and support vehicle.
Remove plug from adjustment hole in backing plate. Turn adjusting nut
until shoes lock wheel. Back adjuster off until wheel turns freely or
with very slight drag. Measured clearance between linings and braking
surface of drum should be .024" (.60 mm).

       BRAKE PEDAL HEIGHT ADJUSTMENTS
         1) Brake pedal height is measured from face of pedal pad to
asphalt sheet under carpet. To adjust clearance, loosen stoplight
switch and lock nut on brake push rod. See Fig. 1.
         2) Adjust pedal height by turning push rod. See BRAKE PEDAL
HEIGHT table for correct specification. After setting pedal height,
tighten lock nut on push rod. Adjust stoplight switch and tighten
switch lock nut.

BRAKE PEDAL HEIGHT TABLE
 

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo