Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1989 transmission removal and installation at

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download transmission removal and installation at documenatation <<

Text preview - extract from the document

                     TRANSMISSION REMOVAL & INSTALLATION - A/T

                                      1988 Toyota Celica




         1988 AUTOMATIC TRANSMISSION REMOVAL
         Toyota

         Camry & Celica (2WD)

NOTE:   The torque converter drive plate runout for all Toyota
        models is .008" (.20 mm). Measure runout on face of drive
        plate as close to ring gear as possible.

    REMOVAL
         1) Disconnect negative battery cable. Remove airflow meter
and air cleaner. Disconnect neutral safety switch connector and all
external electrical connectors. Remove ground strap.

         2) Disconnect transaxle throttle valve cable at throttle
linkage and remove cable from bracket. Remove transaxle case
protector and disconnect speedometer cable. Disconnect shift control
cable at lever and remove from bracket.
         3) Disconnect oil cooler hoses and remove starter motor
bolts. Remove 2 upper transaxle-to-engine bolts. Remove insulator
bracket set bolt for rear engine mount. Raise and support vehicle.
         4) Drain transaxle oil. Disconnect and plug oil cooler
hoses. Remove left front fender apron. Disconnect both axle shafts
from transaxle. Remove lower suspension crossmember. Using pliers,
remove snap ring on center axle shaft bearing bracket. Remove bearing
bracket bolt and pull center axle shaft assembly out.
         5) Disconnect control cable clamp and remove crossmember
bolts supporting center mounts of engine. Remove crossmember. Remove
stabilizer bar and left steering knuckle from lower control arm. Pull
steering knuckle outward and remove left axle shaft.
         6) Remove bellhousing cover and remove 6 bolts attaching
torque converter to drive plate. On Camry, remove
engine-to-transmission stiffener plate.
         7) On all models, support engine with jack stand and secure
transaxle jack under transaxle. Lower rear end of transaxle and
remove remaining transaxle-to-engine bolts. Separate transaxle from
engine and lower transaxle assembly.

    INSTALLATION
         1) Apply multipurpose grease to center hub of torque
converter. Install one guide pin in threaded mounting pad of torque
converter to aid in aligning torque converter. Distance from torque
converter drive lug to engine mating surface of transaxle should be
at least .51" (13 mm).
         2) Reverse removal procedure to complete installation of
transaxle. Torque converter bolts are color coded. Install Gray bolt
first, then the remaining 5 bolts. Tighten torque converter bolts to
20 ft. lbs. (27 N.m).
         3) Tighten transaxle-to-engine 10 mm bolts to 34 ft. lbs.
(46 N.m), and 12 mm bolts to 47 ft. lbs. (64 N.m). Fill transaxle to
proper capacity. Check and adjust throttle cable and control cable.

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo