Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1989 wiper washer system

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download wiper washer system documenatation <<

Text preview - extract from the document

                                 WIPER/WASHER SYSTEM

                                      1988 Toyota Celica




         1988 ACCESSORIES/SAFETY EQUIPMENT
         Toyota Wiper/Washer Systems

         Toyota; All Models.

    DESCRIPTION & OPERATION
         All models are equipped with a 2-speed wiper motor. An
optional intermittent wiper system is also available. Front wiper
motors are protected by an internal circuit breaker.

    TESTING

    FRONT WIPER MOTOR
         Tercel
         1) Connect battery positive lead to terminal No. 2. Connect
negative lead to motor body. Motor should operate at low speed.
         2) Connect battery positive lead to terminal No. 1. Connect
negative lead to motor body. Ensure motor operates at high speed.
         3) To check automatic park operation, connect battery
positive lead to terminal No. 2. Connect negative lead to motor body.
Operate motor at low speed. Disconnect terminal No. 2 and stop motor
operation anywhere except "stop" position.
         4) Connect a jumper wire between terminals No. 2 and 3.
Connect battery positive lead to terminal No. 4. After motor
operates, ensure motor stops running at "stop" position.

         All Other Models
         1) Connect lead from negative battery terminal to wiper motor
body. Connect lead from battery positive terminal to terminal No. 2.
Motor should operate at low speed. Disconnect positive lead.
         2) Connect positive lead to terminal No. 1. Motor should
operate at high speed. If operation is not as specified, replace
wiper motor.
         3) Ensure motor stops at correct position. Run motor at low
speed. Stop motor at any position except "stop" position by
disconnecting positive and negative leads.
         4) Connect positive lead from battery to terminal No. 4.
Connect negative lead to motor body. Install jumper wire between
terminals No. 2 and 3. Motor should stop running at same position
after motor operates again. Replace motor as necessary.




Fig. 1: Front Wiper Motor Terminal Identification
Courtesy of Toyota Motor Sales, U.S.A., Inc.

    REAR WIPER SWITCH
         4Runner
         Inspect continuity between terminals for each switch position
shown in REAR WIPER SWITCH TABLE below. If continuity is not as
specified, replace switch or bulb and retest.

REAR WIPER SWITCH TABLE
 

◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo