Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1994 wiper washer system

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download wiper washer system documenatation <<

Text preview - extract from the document

                                 WIPER/WASHER SYSTEM

                                       1994 Toyota Celica




          1994 ACCESSORIES & EQUIPMENT
          Toyota Motor Sales, U.S.A., Inc. - Wiper/Washer System

          Celica

    * PLEASE READ THIS FIRST *
WARNING: Vehicle is equipped with a driver's side air bag. Use extreme
         caution while servicing components on steering column.
         Ensure ignition switch is in LOCK position and negative
         battery cable is disconnected for at least one minute before
         starting service. DO NOT apply electrical power to any
         component on steering column without disconnecting air bag
         control unit. Information labels are attached to air bag
         components. Follow all notices on labels. Use only DVOM with
         minimum of 10-k/ohms impedance to check ANY circuit.

    DESCRIPTION & OPERATION
         Celica is equipped with 2-speed wiper motors. An intermittent
wiper system is optional. Front wiper motors are protected by an
internal circuit breaker. Celica is also equipped with rear wiper.

    TESTING

    FRONT WIPER MOTOR TEST
         1) Using 12-volt battery, connect jumper wire from positive
battery terminal to wiper motor terminal No. 2. See Fig. 1. Connect
another jumper wire between negative battery terminal and wiper motor
body or motor ground wire location at mounting bolt hole. Motor should
operate at low speed.
         2) Remove jumper wire from terminal No. 2. Reconnect jumper
wire to wiper motor terminal No. 1. Motor should operate at high
speed. Remove jumper wire from terminal No. 1 and reconnect jumper
wire to wiper motor terminal No. 2. With motor running at low speed,
stop motor at any position except PARK position by disconnecting
jumper wire from terminal No. 2. Install another jumper wire between
wiper motor terminals No. 2 and 3.
         3) Ensure motor body ground is still connected to negative
battery terminal. Connect positive battery terminal jumper wire to
wiper motor terminal No. 4. Motor should start running and then stop
at PARK position. Replace motor if operation is not as described.




Fig. 1: Identifying Front Wiper Motor Terminals
Courtesy of Toyota Motor Sales, U.S.A., Inc.

    FRONT WIPER SWITCH TEST
         With wiper switch in specified position, ensure continuity
exists between terminals listed. See WIPER SWITCH CONTINUITY TEST
table. See Fig. 2. Replace wiper switch assembly if continuity is not
as specified.

WIPER SWITCH CONTINUITY TEST TABLE
 

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo