Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1993 INSTRUME
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download INSTRUME documenatation <<Text preview - extract from the document INSTRUMENT PANEL
1993 Toyota Celica
1993 ACCESSORIES/SAFETY EQUIPMENT
Toyota Instrument Panels
Celica
* PLEASE READ THIS FIRST *
WARNING: Celica is equipped with a driver-side air bag; use extreme
caution while working around steering column. To disable air
bag system, ensure ignition switch is in LOCK position and
negative battery terminal is disconnected for at least one
minute before attempting any repair. DO NOT apply electrical
power to any instrument panel connector without disconnecting
air bag control unit. Information labels are attached to air
bag components. Follow all notices on labels. Use only DVOM
(volt/ohmmeter) with minimum of 10-k/ohm impedance to check
ANY circuit.
DESCRIPTION & OPERATION
GAUGES
Standard instrument clusters contain fuel and temperature
gauges with tell-tale warning lights. Some optional instrument panels
are equipped with a tachometer, oil pressure gauge and voltmeter.
Gauge internal operating components use either a 2-terminal bimetallic
strip type, or a 3-terminal coil type. The 2-terminal type gauges are
generally used on clusters without tachometers.
SWITCHES
Celica contains a hazard warning switch and cruise control
main ON/OFF switch on instrument panel. Celica uses a combination
switch for headlight, turn signal, wiper/washer, and cruise control
switches. Combination switch is mounted on steering column. For
testing and/or removal and installation procedures for combination
switch components, see STEERING COLUMN SWITCHES article in the
ACCESSORIES/SAFETY EQUIPMENT section.
TESTING - GAUGES
FUEL GAUGE & WARNING LIGHT
Fuel Gauge And Wiring Harness Operational Test
1) Unplug fuel tank sending unit connector. Turn ignition on.
If fuel gauge indicates EMPTY, go to next step. If fuel gauge does not
indicate EMPTY, repair short circuit in wiring harness. See
appropriate chassis WIRING DIAGRAMS article in WIRING DIAGRAMS
section.
2) Connect a 12-volt, 3.4-watt test light between appropriate
terminals of sending unit wiring harness connector. See FUEL GAUGE &
HARNESS TEST table. See Fig. 1.
3) With ignition on, test light should flash and gauge needle
should move toward FULL. If test light does not flash and gauge needle
does not move, check wiring harness for open circuit. Repair or
replace as necessary. If wiring harness checks good, replace fuel
gauge.
FUEL GAUGE & HARNESS TEST TABLE
◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo