Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Celica 1988-1989.1993-1994.2000 Approved Toyota Celica 1993 SUN_ROOF

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document
SUN_ROOF


>> Download SUN_ROOF documenatation <<

Text preview - extract from the document
                                   SUN ROOF - POWER

                                      1993 Toyota Celica




         1993 ACCESSORIES/SAFETY EQUIPMENT
         Toyota Power Sun Roof

         Celica

    DESCRIPTION & OPERATION
          The ignition switch must be in ON position for sun roof to
operate. The sun roof has a tilt mode and sliding mode. When closing
sun roof in sliding mode, sun roof will stop partway until sun roof
switch is pressed a second time.

    ADJUSTMENTS
NOTE:   Remove sun roof trim plates from top of sun roof opening
        before making adjustments.

    SUN ROOF HEIGHT
         Close sun roof fully. Measure sun roof height. Roof panel
should be even with glass weatherstrip within 0.04" (1.0 mm). If
adjustment is required, install or remove shims between bracket and
sun roof. Recheck sun roof height.

    SUN ROOF CLEARANCE & ALIGNMENT
         Closing Clearance
         If sun roof closing clearances are unequal between right and
left sides, loosen sun roof slider mount nuts. Move either side
forward or backward as required. Tighten sun roof slide mount nuts.
Recheck sun roof alignment and operation.

         Front-To-Rear Alignment
         If front-to-rear position of sun roof is incorrect, loosen
sun roof slider mount nuts. Move sun roof to front or rear as
necessary. Tighten sun roof slider mount nuts.

         Side-To-Side Alignment
         If sun roof is mounted to right or left of center line in
roof opening, loosen sun roof slider mount nuts. Move sun roof right
or left as necessary. Tighten sun roof slider mount nuts.

    TROUBLE SHOOTING
NOTE:   Ensure all component terminals and ground connections are
        clean and tight. Check possible faults in order listed.
        Repair or replace components and circuits as necessary.

         Power Sun Roof Operates Abnormally
         Defective GAUGE fuse. Defective POWER fuse. Defective power
main relay. Defective power sun roof switch. See SUN ROOF SWITCH under
TESTING. Defective limit switch. See LIMIT SWITCH under TESTING.
Defective motor. See MOTOR under TESTING. Defective sliding roof
control relay. See CONTROL RELAY under TESTING. Defective wire
harness.

    TESTING
        CONTROL RELAY
         See CONTROL RELAY LOCATION table for relay location. Unplug
relay connector. Check for continuity or voltage as indicated at
control relay connector terminals with sun roof switch or limit switch
in specified positions. See appropriate CONTROL RELAY TEST table. If
test results are as specified, replace control relay. If test results
are not as specified, repair or replace appropriate switch or wire.
See Fig. 1.

CONTROL RELAY LOCATION TABLE



◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo