Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 1998-2003 Approved FSM 17 dribel insp

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download insp documenatation <<

Text preview - extract from the document

                                                                                                   SR-3
                                    STEERING   -   DRIVE BELT


                                     DRIVE BELT                                                    SR05O-06


                                     INSPECTION
                                     INSPECT DRIVE BELT
                                     (a) Visually check the belt for excessive wear, frayed cords,
                                            etc.
                                     If any defect has been found, replace the drive belt.
                                     HINT:
                          P06717     Cracks on the rib side of a drive belt are considered acceptable.
                                     If the missing chunks from the ribs are found on the drive belt,
                                     it should be replaced.
                                     (b) Measure the belt deflection.
                                            Pressing force: 98 N (10 kgf, 221 lbf)
                                            New belt: 8 to 10 mm (0.315 to 0.394 in.)
                                            Used belt: 11 to 14 mm (0.433 to 0.551 in.)
                                     If the belt deflection is not as specified, adjust it.




    DENSO           Borroughs        (c)     Using a belt tension gauge, measure the belt tension.
                                             Belt tension gauge:
                                             DENSO BTG-20 (95506-00020)
                                             Borroughs No. BT-33-73F
                                             Drive belt tension:
                                             New belt: 132 - 154 lb
                                             Used belt: 55 - 88 lb
                                     If the belt tension is not as specified, adjust it.
                           Z00038



                                     HINT:
                                      S      "New belt" refers to a belt which has been used less than
                                             5 minutes on a running engine.
                                      S      "Used belt" refers to a belt which has been used on a run-
                                             ning engine for 5 minutes or more.
CORRECT     WRONG   WRONG             S      After installing a belt, check that it fits properly in the
                                             ribbed grooves.
                                      S      Check with your hand to confirm that the belt has not
                          P06723             slipped out of the groove on the bottom of the pulley.
                                      S      After installing a new belt, run the engine for about 5 min-
                                             utes and recheck the belt tension.




                                                         Author :             Date :               1399

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo