Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 1998-2003 Approved FSM 19 gdosy regpro
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download regpro documenatation <<
Text preview - extract from the document
BE-142
BODY ELECTRICAL - GARAGE DOOR OPENER SYSTEM
GARAGE DOOR OPENER SYSTEM BE0G2-04
REGISTRATION PROCEDURE
1. NEW CODE REGISTRATION
NOTICE:
S If pressing the switch of the original transmitter to
register the code, the system might operate.
S When registering the transmitter codes such as for
garage or gate, check that there is nobody around
those places then register.
(a) Press the switch for the item to be registered for 20 se-
conds
HINT:
When transferring to registration mode, LED (red) blinks in 1 Hz
cycle.
(b) In the condition of (a), bring the original transmitter to with-
in 1-inch area around the garage door opener and press
the switch. (code transmitting).
HINT:
When code registration completes correctly, LED (red) blinks in
5.6 Hz cycle.
I19481
2001 SIENNA (RM787U)
Author : Date : 1660
BE-143
BODY ELECTRICAL - GARAGE DOOR OPENER SYSTEM
New code registration timing chart
PRESSED
GARAGE DOOR
OPENER SWITCH
PRESSED
ENTER
20 sec
LEARN MODE
EXIT
LED ON
OPERATION
OFF
LED flashes
at a rate of 1 Hz
LED flashes at a
rate of 5.6 Hz
ON
ORIGINAL
TRANSMITTER
OFF
I03487
If a code can not be registered, observe the following condi-
tions.
HINT:
S If the battery of original transmitter is consumed.
S Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.
S This system is not applicable to the garage door opener
which had been made before 1982.
2. CODE DELETION
(a) Press the switches at both ends of garage door opener
simultaneously for 20 seconds.
HINT:
When transferring to deletion mode, LED (red) blinks in 6 Hz
cycle.
(b) When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.
HINT:
Press the switch until blinking in 6 Hz cycle stops, so that the
default code for check is set.
2001 SIENNA (RM787U)
Author : Date : 1661
BE-144
BODY ELECTRICAL - GARAGE DOOR OPENER SYSTEM
Code deletion timing chart
GARAGE DOOR PRESSED
OPENER SWITCH
(Switch at either end)
Enter in erase mode to erase all 3 channels
PRESSED
ON
CLEAR/DEFAULT 10 SEC LOAD DEFAULT
20 SEC
MODE
OFF
ON
LED
OPERATION
OFF
LED flashes at a rate of 6 HZ
I03488
2001 SIENNA (RM787U)
Author : Date : 1662
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo