Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 04 05 2021t cicc22
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download cicc22 documenatation <<Text preview - extract from the document 05-2043
DIAGNOSTICS - DYNAMIC LASER CRUISE CONTROL SYSTEM 05BEN-01
CRUISE MAIN INDICATOR LIGHT CIRCUIT
CIRCUIT DESCRIPTION
When the cruise control main switch is ON, CRUISE main indicator light and READY indicator light comes
on.
This indicates the control condition (the front vehicle, vehicle-to-vehicle distance, and set vehicle speed)
and fail-safe state through the multiplex communication system.
The master warning light, cruise main indicator light and vehicle-to-vehicle distance information come on
as the alarm buzzer sounds.
HINT:
If the front vehicle in the same lane significantly decrease the vehicle speed or another vehicle cuts in front
of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance will shorten.
At this time, the system sounds the buzzer and the master warning light blinks to warn the driver.
INSPECTION PROCEDURE
1 READ VALUE OF HAND-HELD TESTER
(a) Connect the hand-held tester to the DLC3.
(b) Check the cruise main indicator light using DATA LIST.
ECM:
Measurement Item /
Item Normal Condition Diagnostic Note
Display (Range)
Cruise control system stand by ON OFF : Change ON/OFF
CCS READY M "1"
condition (Main CPU) / ON or OFF each time Main SW is Pushed in.
Cruise control system stand by ON OFF : Change ON/OFF
CCS READY S "1"
condition (Sub CPU) / ON or OFF each time Main SW is Pushed in.
Cruise indicator signal (Main CPU) ON : "CCS READY" ON
CCS INDICATOR M "2"
/ ON or OFF OFF : "CCS READY" OFF
Cruise indicator signal (Sub CPU) ON : "CCS READY" ON
CCS INDICATOR S "2"
/ ON or OFF OFF : "CCS READY" OFF
HINT:
"1" is OK, but "2" is NG DTC output or ECM failure
OK PROCEED TO NEXT CIRCUIT INSPECTION
SHOWN ON PROBLEM SYMPTOMS TABLE
(See page 05-2008 )
NG
GO TO COMBINATION METER SYSTEM (See page 05-1525 )
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 2226
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo