Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 04 05 20vj6 cirhnot
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download cirhnot documenatation <<
Text preview - extract from the document
05-1709
DIAGNOSTICS - POWER SLIDE DOOR SYSTEM 05BZD-01
POWER SLIDE DOOR RH DOES NOT OPERATE WHEN USING
INSIDE/OUTSIDE HANDLE (NORMALLY OPERATES WHEN USING
SWITCH*)
* "SWITCH" indicates the satellite switch for the power slide door RH and the power slide door control switch
RH
CIRCUIT DESCRIPTION
S The inside/outside handles have the ability to control operation of the power slide door. Pulling either
handle transmits a request signal to the power slide door ECU RH, which then commands the power
slide door control motor and clutch to open/close the power slide door.
S The slide door lock remote control assy has the handle operation detect switch for detection of switch
operation and also the child protection detect switch for the child lock function that disables the power
slide door control switch RH function while the child lock is ON.
S If there is a malfunction detected in these 2 detection switches or the wire harness, replace the slide
door lock remote control assy RH.
WIRING DIAGRAM
See page 05-1688 .
INSPECTION PROCEDURE
1 OPERATION CHECK
(a) If the power slide door does not operate when tying to open it, proceed to A.
(b) If the power slide door does not operate when tying to close it, proceed to B.
B Go to step 3
A
2 CHECK SLIDE DOOR CLOSER SYSTEM
(a) Check if the slide door closer system operates.
NG GO TO CLOSER SYSTEM (See page 05-1641 )
OK
3 READ VALUE OF HAND-HELD TESTER
(a) Using the hand-held tester, check the DATA LIST for proper functioning of the handle operation detect
switch.
Standard (Power slide door ECU RH):
Diagnostic
Item Measurement Item/Display (Range) Normal Condition
Note
Handle operation detect switch signal ON: Slide door inside/outside handle is pulled
HANDLE SW -
/ON or OFF OFF: Slide door inside/outside handle is not pulled
OK Go to step 6
NG
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 1892
05-1710
DIAGNOSTICS - POWER SLIDE DOOR SYSTEM
4 INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSY RH (HANDLE OP-
ERATION DETECT SWITCH)
(a) Inspect the resistance of the switch.
Handle Operation Standard:
Detect Switch
Terminal No. Lever Position Specified Condition
Unlock 10 k or higher
1-3
Lock Below 1
Door Lock Lever
Lock
Unlock
NG REPLACE SLIDE DOOR LOCK REMOTE
B68910 B69777 CONTROL SUB-ASSY RH
OK
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 1893
05-171 1
DIAGNOSTICS - POWER SLIDE DOOR SYSTEM
5 CHECK WIRE HARNESS (SLIDE DOOR LOCK REMOTE CONTROL ASSY RH
(HANDLE OPERATION DETECT SWITCH) - POWER SLIDE DOOR ECU RH)
Wire Harness Side (a) Disconnect the S23 remote control and P27 ECU connec-
tors.
S23 (b) Check the resistance between the wire harness side con-
Slide Door Lock Remote Control Assy RH nectors.
Standard (Check for open circuit):
Terminal No. Specified Condition
S23-1 - P27-3 (HSW) Below 1
(c) Check the resistance between the S23 remote control
connector and body ground.
Standard (Check for open circuit):
P27
Terminal No. Specified Condition
Power Slide Door ECU RH
S23-3 - Body ground Below 1
NG REPAIR OR REPLACE HARNESS AND
B68450 CONNECTOR
OK
REPLACE POWER SLIDE DOOR ECU RH
6 READ VALUE OF HAND-HELD TESTER
(a) Using the hand-held tester, check the DATA LIST for proper functioning of the child protection detect
switch.
Standard (Power slide door ECU RH):
Diagnostic
Item Measurement Item/Display (Range) Normal Condition
Note
Child protection detect switch signal ON: Child lock lever is LOCK
CHILD LOCK SW -
/ON or OFF OFF: Child lock lever is UNLOCK
OK REPLACE POWER SLIDE DOOR ECU RH
NG
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 1894
05-1712
DIAGNOSTICS - POWER SLIDE DOOR SYSTEM
7 INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSY RH (CHILD
PROTECTION DETECT SWITCH)
Child Protection (a) Inspect the resistance of the switch.
Detect Switch Standard:
Terminal No. Lever Position Specified Condition
Unlock Unlock 10 k or higher
4-5
Lock Below 1
Lock
Child Lock Lever
NG REPLACE SLIDE DOOR LOCK REMOTE
B68911 B69778 CONTROL SUB-ASSY RH
OK
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 1895
05-1713
DIAGNOSTICS - POWER SLIDE DOOR SYSTEM
8 CHECK WIRE HARNESS (SLIDE DOOR LOCK REMOTE CONTROL ASSY (CHILD
PROTECTION DETECT SWITCH) - POWER SLIDE DOOR ECU RH)
Wire Harness Side (a) Disconnect the S23 switch and P27 ECU connectors.
(b) Check the resistance between the wire harness side con-
S23 nectors.
Slide Door Lock Remote Control Assy RH Standard (Check for open circuit):
Terminal No. Specified Condition
S23-5 - P27-18 (CPSW) Below 1
(c) Check the resistance between the S23 switch connector
and body ground.
Standard (Check for open circuit):
Terminal No. Specified Condition
P27
S23-4 - Body ground Below 1
Power Slide Door ECU RH
NG REPAIR OR REPLACE HARNESS AND
B68450 CONNECTOR
OK
REPLACE POWER SLIDE DOOR ECU RH
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 1896
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo