Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 04 29 2041jl02 precaud4

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download precaud4 documenatation <<

Text preview - extract from the document

                                                                                                   29-1
                                       DIFFERENTIAL   -   DIFFERENTIAL SYSTEM (4WD)


DIFFERENTIAL SYSTEM (4WD)
                                                                                                  2900W-02


PRECAUTION
1.    Before disassembly, clean the outside of the rear differential assy and remove any sand or mud
      to prevent it from entering the inside of the assembly during disassembly and installation.
2.    When removing a connected part made of light alloy such as a rear differential carrier cover,
      tap it off with a plastic hammer. Do not attempt to pry it off with a screwdriver.
3.    Always arrange disassembled parts in order and protect them from dust.
4.    Before installation, thoroughly clean and dry each part and then apply hypoid gear oil LSD to
      it. Do not use alkaline cleaner for aluminum or rubber parts and ring gear set bolts. Also, do not
      clean rubber parts such as O-rings or oil seals with white gasoline.
5.    Coat any sliding surface and rotating part with hypoid gear oil LSD.
6.    When holding a component part by a vise, be sure to place an aluminum sheet under the part.
      Do not put it directly on the vise.
7.    Be careful not to damage the contact surfaces of the case. Such damage may cause oil leakage.
8.    Before applying sealant, remove deposited oil sealant and clean the part to be sealed using
      white gasoline.
9.    Do not supply oil immediately after installing sealed parts. Leave it for at least an hour.
10.   Damage on the surface of an oil seal, O-ring or gasket may cause oil leakage. Special attention
      should be paid.
11.   When press-fitting an oil seal, be careful not to damage the oil seal lip and outside periphery.
12.   When replacing a bearing, replace the inner and outer races as a set.




 2005 SIENNA REPAIR MANUAL (RM1163U)

                                                                Author :              Date :      2632

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo