Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 11 21ppx756 x040001
<< Back |
HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download
Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing.
If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download x040001 documenatation <<Text preview - extract from the document16-8
COOLING - ENGINE COOLANT
ENGINE COOLANT
16038-12
REPLACEMENT
Radiator Cap 1. DRAIN COOLANT
(a) Remove the radiator.
Drain Cock Plug CAUTION:
To avoid the danger of being burned, do not remove the ra-
diator cap while the engine and radiator are still hot. Ther-
mal expansion will cause hot engine coolant and steam to
blow out from the radiator.
Drain Cock Plug
(b) Loosen the radiator drain plug and the 2 drain cock plugs,
Radiator Drain Plug
A78313 and drain the coolant.
(c) Tighten the 2 drain cock plugs.
Torque: 13 Nm (130 kgfcm, 9 ftlbf)
2. ADD COOLANT
(a) Tighten the drain plug of the radiator.
(b) Slowly fill the cooling system with coolant.
Capacity: 11.7 liters (12.4 US qts, 10.3 lmp. qts)
NOTICE:
Do not use plain water by itself.
HINT:
S Use of improper coolant may damage the engine cooling system.
S Use only "Toyota Super Long Life Coolant" or similar high quality ethylene glycol based non-silicate,
non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology. (Cool-
ant with long-life hybrid organic acid technology consists of the combination of low phosphates and
organic acids.)
S "Toyota Super Long Life Coolant" is premixed with 50% coolant and 50% deionized water. This coolant
provides protection down to about -35_C (-31_F).
S Observe the coolant level inside the radiator by pressing the inlet and outlet radiator hoses several
times by hand. If the coolant level is low, add coolant.
(c) Install the radiator cap securely.
(d) Fill the radiator reservoir tank with the coolant.
(e) Warm up the engine.
NOTICE:
Warm up the engine until the fan starts running with the A/C, heater and defroster all off.
(f) Press the inlet and outlet radiator hoses several times by hand while warming up the engine.
(g) Stop the engine and wait until the coolant cools down.
(h) Remove the radiator cap and check the coolant level inside the radiator.
(i) If the coolant level is below the full level, perform the steps from (c) through (i) and repeat the operation
until the coolant level stays the full level.
(j) Recheck the coolant level inside the radiator reservoir tank. If it is below the full level by +10 mm, add
the coolant.
3. CHECK FOR ENGINE COOLANT LEAKS
(a) Fill the radiator with coolant and attach a radiator cap tester.
(b) Pump it to 118 kPa (1.2 kgf/cm2), and check for leakage.
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 2508
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo