Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 24 20b6w c540001
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download c540001 documenatation <<
Text preview - extract from the document
50-4
STEERING COLUMN - STEERING
5006O-02
REPAIR
Steering Wheel 1. STEERING OFF CENTER REPAIR PROCEDURE
(a) Inspect steering wheel off center.
Masking Tape
(1) Apply masking tape to the top center of the steering
Steering Column wheel and steering column upper cover.
Upper Cover (2) Drive the vehicle in a straight line for 100 meters at
a constant speed of 35 mph (56 km/h), and hold the
steering wheel to maintain the course.
F16015
Steering Column (3) Draw a line on the masking tape as shown in the il-
Upper Cover lustration.
Marked Line
Steering Wheel
Masking
Tape
F16016
Steering Column (4) Turn the steering wheel to its straight position.
Upper Cover HINT:
Refer to the upper surface of the steering wheel, steering spoke
Marked Line and SRS airbag line for the straight position.
Steering Wheel (5) Draw a new line on the masking tape or the steering
wheel as shown in the illustration.
(6) Measure the distance between the 2 lines on the
masking tape of the steering wheel.
(7) Convert the measured distance to steering angle.
Measured distance 1 mm (0.04 in.) = Steering angle
approximately 1 deg.
HINT:
Make a note of the steering angle.
F16017 (b) Adjust the steering angle.
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 2878
50-5
STEERING COLUMN - STEERING
(1) Draw a line on the RH and LH tie rod and on the RH
and LH rack end, which can easily be seen.
(2) Using a paper gauge, measure the distance from
the RH and LH tie rod ends to the rack end screws.
HINT:
S Measure the RH side and LH side.
Marked Line S Make a note of the measured values.
R00429
(3) Remove the RH and LH boot clips from the rack
boots.
(4) Loosen the RH and LH lock nuts.
(5) Turn the RH and LH rack end by the same amount
(but in different directions) according to the steering
angle.
1 turn 360 deg. of rack end (1.5 mm (0.059 in.) horizon-
tal movement) - 12 deg. of steering angle.
F16018 (6) Tighten the RH and LH lock nuts.
Torque: 74 Nm (755 kgfcm, 55 ftlbf)
NOTICE:
Make sure that the difference in length between RH and LH
tie rod ends and rack end screws are within 1.5 mm (0.059
in.).
(7) Install the RH and LH boot clips.
2005 SIENNA REPAIR MANUAL (RM1163U)
Author : Date : 2879
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo