Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Sienna 2004-2007 Approved SRM 27 20su0 x040001

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download x040001 documenatation <<

Text preview - extract from the document

60-62
                    SUPPLEMENTAL RESTRAINT SYSTEM      -   AIR BAG SENSOR REAR RH
                                                                                                      600JM-02


REPLACEMENT
HINT:
Replacement procedure of the LH side is the same as that of the RH side except for step 9.
1.    PRECAUTION (SEE PAGE 60-1 )
2.    DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 )
3.    REMOVE REAR DOOR SCUFF PLATE RH (SEE PAGE 76-27 )
4.    REMOVE REAR DOOR WEATHERSTRIP RH (SEE PAGE 76-27 )
5.    REMOVE BACK DOOR WEATHERSTRIP (SEE PAGE 76-27 )
6.    REMOVE BACK DOOR SCUFF PLATE (SEE PAGE 76-27 )
7.    REMOVE LAP BELT OUTER ANCHOR COVER REAR NO.2 SEAT (SEE PAGE 76-27 )
8.    REMOVE QUARTER TRIM PANEL ASSY FRONT RH (SEE PAGE 76-27 )
9.    REMOVE AIR DUCT ASSY
(a) Remove the screw and the air duct assy.


                                               10.   REMOVE AIR BAG SENSOR REAR RH
                                               (a)   Disconnect the connector of the airbag sensor rear RH.
                                               (b)   Remove the 2 bolts and the airbag sensor rear RH.




                                      H42782



11. INSTALL AIR BAG SENSOR REAR RH
(a) Check that the ignition switch is OFF.
(b) Check that the battery negative (-) terminal is disconnected.
NOTICE:
Do not start the operation for 90 seconds after removing the terminal.
(c) Install the airbag sensor rear RH with the 2 bolts.
    Torque: 17.5 Nm (178 kgfcm, 13 ftlbf)
NOTICE:
 S  Installation of the connector is performed with the airbag sensor rear RH installed. Make sure
    the airbag sensor rear RH is installed with the specified torque.
 S  If the airbag sensor rear RH has been dropped, or there are cracks, dents or other defects in
    the case, bracket or connector, replace the airbag sensor rear RH with a new one.
 S  When installing the airbag sensor rear RH, take care that the SRS wiring does not interfere with
    other parts and is not pinched between other parts.
(d) Connect the connector of the airbag sensor rear RH.
(e) Check that no play is identified.
12. INSPECT SRS WARNING LIGHT (SEE PAGE 05-770 )




2005 SIENNA REPAIR MANUAL (RM1163U)

                                                                 Author :           Date :              3057

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo