Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra ac coouni ovi

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download ovi documenatation <<

Text preview - extract from the document

AC-28
        AIR CONDITIONING    -   COOLING UNIT


                   COOLING UNIT                                                 AC271-03


                   ON-VEHICLE INSPECTION
                   1.    INSPECT FOR LEAKAGE OF REFRIGERANT
                   (a)   Remove the glove compartment door.
                   (b)   Remove the lower No. 2 finish panel.
                   (c)   Remove the lower center cover.
                   (d)   Remove the lower LH finish panel.
                   (e)   Remove the lower cover (See page BO-111).

                   (f)    Remove the blower resistor.
                          (1) Disconnect the connector.
                          (2) Remove the 2 screws and blower resistor.
                   (g) Using a gas leak detector, check for leakage.
                   If there is leakage, check the tightening torque at the joints or
                   check the evaporator.
                   (h) Install the blower resistor with the 2 screws.
                   (i)    Install the lower cover.
          I11127   (j)    Install the lower LH finish panel.
                   (k) Install the lower center cover.
                   (l)    Install the lower No. 2 finish panel.
                   (m) Install the glove compartment door (See page BO-120).
                   2.     INSPECT EXPANSION VALVE
                   (a) Check quantity of gas during refrigeration cycle.
                   (b) Set the manifold gauge set.
                   (c) Run the engine.
                          (1) Run the engine at 1,500 rpm for at least 5 minutes.
                          (2) Then check that the high pressure reading is 1.37
                                 to 1.57 Mpa (14 to 16 kgm/cm2, 199 to 288 psi).
                   (d) Check the expansion valve.
                   If the expansion valve is faulty, the low pressure reading will
                   drop to 0 kPa (0 kgf/cm2, 0 psi).
                   HINT:
                   When the low pressure reading drops to 0 kPa (0 kgf/cm2, 0
                   psi), there is no difference in temperature between the IN and
                   OUT sides of the receiver.




                   3.     INSPECT THERMISTOR RESISTANCE
                   (a)    Disconnect the connector.
                   (b)    Measure the resistance between terminals.
                          Standard resistance: 1,500  at 25

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo