Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra ata750ea atf adju
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download adju documenatation <<
Text preview - extract from the document
AT-4
AUTOMATIC TRANSMISSION (A750E, A750F) - AUTOMATIC TRANSMISSION FLUID
Refill Plug AUTOMATIC TRANSMISSION
FLUID AT145-01
ADJUSTMENT
1. BEFORE TRANSMISSION FILL
S This transmission requires Toyota Genuine ATF WS
transmission fluid.
S After servicing the transmission, you must refill the trans-
mission with the correct amount of fluid.
S Maintain the vehicle in a horizontal position while adjust-
ing fluid level.
S On vehicles equipped with active suspension, turn the
suspension control switch OFF if you jack up the vehicle
while the engine is running.
S Proceed to step 2 if you replaced the entire transmission,
transmission pan, drain plug, valve body and/or torque
converter.
Overflow Plug S Proceed to step 3 after removing the refill plug if you re-
D14137
placed the transmission hose and/or output shaft oil seal.
2. TRANSMISSION PAN FILL
(a) Remove the refill plug and overflow plug.
(b) Fill the transmission through the refill hole until fluid be-
gins to trickle out of the overflow tube.
Specified Fluid Level Overflow Tube (c) Reinstall the overflow plug.
3. TRANSMISSION FILL
(a) Fill the transmission with the correct amount of fluid as
listed in the table below.
D14351 (b) Reinstall the refill plug to avoid fluid splash.
Repair Fill Amount
Transmission hose and pipe removal 0.6 L (0.63 US qts, 0.53 Imp qts)
Output shaft oil seal replacement 0.4 L (0.42 US qts, 0.35 Imp qts)
Transmission pan and drain plug remov-
1.3 L (1.37 US qts, 1.14 Imp qts)
al
Transmission valve body removal 3.9 L (4.12 US qts, 3.43 Imp qts)
Torque converter removal 5.3 L (5.60 US qts, 4.66 Imp qts)
Entire transmission assembly 7.2 L (7.61 US qts, 6.34 Imp qts)
HINT:
If you cannot add the listed amount of fluid, do the following:
S Install the refill plug.
S Allow the engine to idle with the air conditioning
OFF.
S Move the shift lever through entire gear range to cir-
culate fluid.
S Wait for 30 seconds with the engine idling.
S Stop the engine.
S Remove the refill plug and add fluid.
S Reinstall the refill plug.
AT-5
AUTOMATIC TRANSMISSION (A750E, A750F) - AUTOMATIC TRANSMISSION FLUID
4. FLUID CIRCULATION
(a) Allow the engine to idle with the air conditioning OFF.
(b) Move the shift lever through entire gear range to circulate
fluid.
5. FLUID TEMPERATURE CHECK
(a) With hand-held tester
(1) Connect the hand-held tester to the DLC3.
(2) Select the tester menus: OBD/MOBD, ENGINE,
DATA LIST and A/T.
(3) Check A/T OIL TEMP.
(4) Allow the engine to idle until the fluid temperature
reaches 46_C (115_F).
(b) Without hand-held tester (Using A/T OIL TEMP indicator)
DLC3: CG
(1) Create a short circuit between CG (4) and TC (13)
of the DLC3 terminals using SST.
1 2 3 4 5 6 7 8 SST 09843-18040
(2) Move the shift lever back and forth between N and
9 10 11 12 13 14 15 16
D at 1.5 seconds interval for six seconds.
(3) The A/T OIL TEMP indicator comes on for two se-
conds when the combination meter starts to detect
TC D13649 the fluid temperature.
(4) The A/T OIL TEMP indicator comes on again when
the fluid temperature reaches 46_C (115_F) and
blinks when it exceeds 56_C (130_F).
(5) Allow the engine to idle until the fluid temperature
reaches 46_C (115_F).
HINT:
The fluid temperature should be less than 30_C (86_F) before
check the fluid temperature.
6. FLUID LEVEL CHECK
NOTICE:
The fluid temperature must be between 46_C (115_F) and
56_C (130_F) to check the fluid level.
Specified Fluid Level Overflow Tube (a) Remove the overflow plug with the engine idling.
(b) Check that the fluid comes out of the overflow tube.
If fluid does not come out, proceed to step 7.
If fluid comes out, wait until the over-flow slows to a trickle and
D14351 proceed to step 8.
AT-6
AUTOMATIC TRANSMISSION (A750E, A750F) - AUTOMATIC TRANSMISSION FLUID
7. TRANSMISSION REFILL
(a) Install the overflow plug.
(b) Stop the engine.
(c) Remove the refill plug.
(d) Add 0.4 liters (0.42 US qts, 0.35 lmp qts) of fluid.
(e) Allow the engine to idle and wait for 10 seconds.
(f) Proceed to step 6.
8. COMPLETE
(a) Install the overflow plug with a new gasket.
Torque: 20 Nm (205 kgfcm, 15 ftlbf)
(b) Stop the engine.
(c) Install the refill plug with a new gasket.
Torque: 39 Nm (400 kgfcm, 29 ftlbf)
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo