Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra be commet insp
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download insp documenatation <<
Text preview - extract from the document
BE-86
BODY ELECTRICAL - COMBINATION METER
BE2ME-01
INSPECTION
1. INSPECT SPEEDOMETER ON-VEHICLE
Using a speedometer tester, check the speedometer for indica-
tion error and check operation of the odometer.
HINT:
Tire wear and tire over or under inflation will increase the indica-
tion error.
USA (mph) CANADA (km/h)
Standard Indication Allowable Range Standard Indication Allowable Range
20 19 to 22 20 17.5 to 21.5
40 39 to 42.5 40 38 to 42
60 59.5 to 63.5 60 58 to 63
80 79.5 to 84 80 78 to 84
100 100 to 105 100 98.5 to 104.5
- 120 119 to 125
- 140 139 to 146
- 160 159 to 167
If the error is excessive, replace the speedometer.
Combination Meter Assy: 2. INSPECT INPUT VEHICLE SPEED SIGNAL WAVE-
FORM (A/T)
(a) Remove the combination meter with connectors still con-
nected.
(b) Connect the oscilloscope to terminal A-24 and body
ground.
A-24 (c) Start the engine.
I28306
(d) Check the signal waveform according to the condition(s)
in the table below.
Item Condition
Tool setting 5 V/DIV, 20 ms/DIV
Vehicle condition Driving at approx. 20 km/h (12 mph)
GND OK:
As shown in the illustration
HINT:
I28902 As vehicle speed increases, the cycle of the signal waveform
narrows.
BE-87
BODY ELECTRICAL - COMBINATION METER
3. INSPECT INPUT VEHICLE SPEED SIGNAL WAVE-
FORM (M/T)
(a) Shift the shift lever to neutral.
(b) Jack up either of the front wheel.
V1 (c) Turn the ignition switch to ON.
(d) Measure the voltage between terminals 2 and 3 of speed
sensor when the front wheel is turning slowly.
Standard voltage:
I28903 Voltage is generated intermittently.
10 to 14 V
0
Turn the wheel
4. INSPECT TACHOMETER ON-VEHICLE
(a) Connect a tune-up test tachometer, and start the engine.
NOTICE:
S Reversing the connection of the tachometer will dam-
age the transistors and diodes inside the tachometer.
S When removing or installing the tachometer, be care-
ful not to drop or subject it to heavy shocks.
(b) Compare the tester and tachometer indications.
DC 13.5 V at 20◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo