Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra be psbwsyex insp
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download insp documenatation <<
Text preview - extract from the document
BE-122 BODY ELECTRICAL - POWER SLIDE BACK WINDOW SYSTEM (Except
Double Cab)
BE2LJ-01
INSPECTION
1. INSPECT POWER SLIDE BACK WINDOW SWITCH
CONTINUITY
Switch Position Tester Connection Specified Condition
OPEN 1 - 3, 2 - 6 Continuity
OFF 2 - 3, 2 - 6 Continuity
CLOSE 1 - 6, 2 - 3 Continuity
I24634 If the continuity is not as specified, replace the switch.
2. CHECK POWER SLIDE BACK WINDOW MOTOR PTC
2 1
THERMISTOR OPERATION
(a) Disconnect the connector from the window motor.
(b) Connect the positive (+) lead from the ammeter to termi-
nal 1 of the motor connector and the negative (-) lead to
the negative terminal of the battery.
(c) Connect the positive (+) lead from the battery to terminal
2 of the motor connector, and slide the window to the fully
I24765 closed position.
(d) Continue to apply voltage and check that the current
2 1
changes to less than 1 A in 4 to 90 seconds.
(e) Disconnect the leads from the terminals.
(f) Approximately 60 seconds later, connect the positive (+)
lead from the battery to terminal 1 and the negative (-)
lead to terminal 2, and check that the window begins to
slide open.
If operation is not as specified, replace the regulator and motor
I24766 assembly.
3. INSPECT POWER RELAY CONTINUITY
2 Tester Connection Specified Condition
1
3-5 No continuity
3 5
Continuity
3-5
5 (When battery voltage is applied to terminals 1 and 2)
1 2
3
If the continuity is not as specified, replace the relay.
N14863
1 Driver Side J/B 4. CHECK INTEGRATION RELAY
2
3 Remove the integration relay from the driver side J/B, and
4
5
6
check the voltage or continuity of each terminal on the driver
7 side J/B side (see page BE-128).
8
9
10
11
12
13
14
15
I11896
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo